Results 21 to 30 of about 3,337 (294)

Accessing Divergent Main-Chain-Functionalized Polyethylenes via Copolymerization of Ethylene with a CO2/Butadiene-Derived Lactone

open access: yes, 2021
Carbon dioxide (CO2) has been used as a sustainable comonomer in the synthesis of different functional polymers including polycarbonates, polyurea, and polyurethane.
Shan Tang   +5 more
core   +1 more source

Unveiling the Effects of Thermal Aging on the Oxidative Stability of Biobased Low-Density Polyethylenes [PDF]

open access: yesACS Omega
Joanna Aniśko-Michalak   +5 more
doaj   +2 more sources

Friction and wear of two polyethylenes under different tribological contact conditions

open access: yes, 2021
Tribological properties of ultrahigh-molecular weight polyethylene (UHMWPE) and cross-linked polyethylene (XLPE) were studied in two different wear modes. Firstly, reciprocating sliding wear studies under non-conformal contact investigated the effects of
Wäsche, Rolf   +2 more
core   +1 more source

The effect of modality on linear low-density polyethylene crystallization behaviour at high and very high supercoolings; pp. 53–57 [PDF]

open access: yesProceedings of the Estonian Academy of Sciences, 2009
Isothermal crystallization rates of uni- and bimodal linear low density polyethylenes having similar average molar mass and branching content were analysed at various temperatures in a very high supercooling range by means of a novel method – chip ...
Triin Märtson   +3 more
doaj   +1 more source

Direct Synthesis of Polyethylene Thermoplastic Elastomers Using Hybrid Bulky Acenaphthene-Based α-Diimine Ni(II) Catalysts

open access: yesMolecules, 2023
Recently, polyolefin thermoplastic elastomers can be obtained directly using ethylene as a single feedstock via α-diimine nickel-catalyzed ethylene chain walking polymerization.
Hui Wang   +3 more
doaj   +1 more source

Correlation of cross-linking as measured by the trans-vinylene index and in vitro wear of polyethylene from various acetabular liner brands

open access: yesBone & Joint Research
Aims: Highly cross-linked polyethylene (HXLPE) greatly reduces wear in total hip arthroplasty, compared to conventional polyethylene (CPE). Cross-linking is commonly achieved by irradiation. This study aimed to compare the degree of cross-linking and in
Peter Wahl   +8 more
doaj   +1 more source

Recent update on crosslinked polyethylene in total hip arthroplasty

open access: yesSICOT-J, 2020
More than two decades after their clinical introduction, crosslinked polyethylenes (XLPE) have been widely adopted. Though concerns were initially raised regarding oxidation and brittleness, on a large scale, the first generation of XLPE continues to be ...
Langlois Jean, Hamadouche Moussa
doaj   +1 more source

Ultra-strong long-chain polyamide elastomers with programmable supramolecular interactions and oriented crystalline microstructures

open access: yesNature Communications, 2019
Long-chain polyamides could bridge the gap between traditional polyamides and polyethylenes. Here the authors show the preparation of diamide diene monomers derived from natural resources coupled by thiol-ene addition copolymerization to form long-chain ...
Lingzhi Song   +6 more
doaj   +1 more source

Photodegradation of polyethylenes: Comparative effect of Fe and Ca-stearates as pro-oxidant additives

open access: yes, 2010
The effect of iron and calcium stearates on the degradation of polyethylene (LDPE and LLDPE), under natural and artificial exposure, has been studied. The activity of stearates has been evaluated by chemiluminescence and FTIR of polyethylenes.
T. Corrales   +13 more
core   +1 more source

Comparison of the influence of Cu micro- and nano-particles on the thermal properties of polyethylene/Cu composites

open access: yeseXPRESS Polymer Letters, 2009
Polyethylene (LDPE, LLDPE and HDPE) composites with different copper (micro- and nano-sized particles) contents were prepared by melt mixing and compression moulding.
doaj   +1 more source

Home - About - Disclaimer - Privacy