Results 131 to 140 of about 21,355 (312)
Ka-Band GaN-on-Si 4W MMIC High Power Amplifier for Millimetre-wave Radar
This contribution presents the design of a Monolithic Microwave Integrated Circuits (MMIC) power amplifier (PA) developed for radar applications in the upper Ka-band (35GHz - 40GHz).
Giannini, Franco +5 more
core +1 more source
In this paper, a high-efficiency compact power amplifier is designed and fabricated with a 0.25 μm GaN high electron mobility transistor (HEMT) to meet the demands of a high integration level and high efficiency for microwave wireless power transfer (WPT)
Caoyu Li +5 more
doaj +1 more source
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios +5 more
wiley +1 more source
Recently, dynamic power supply voltage techniques, such as an Envelope Elimination and Restoration power amplifier (EER-PA) or Envelope-Tracking Power amplifier (ET-PA), have been attracting much attention because they can maintain high efficiency in ...
Morris, Kevin +8 more
core +1 more source
This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
LOW POWER SI CLASS E POWER AMPLIFIER AND RF SWITCH FOR HEALTH CARE
This research was to design a 2.4 GHz class E Power Amplifier (PA) for health care, with 0.18um Semiconductor Manufacturing International Corporation CMOS technology by using Cadence software.
Wei Cai1 , Jian Xu,2 and Liang Huang3
core +1 more source
Phase‐field simulations coupled with dislocation‐density‐based crystal plasticity modeling reproduce γ′ rafting behavior in single‐crystal Ni‐based superalloys under varied loading conditions. The model captures both macroscopic creep and microscopic morphology evolution, with results matching high‐temperature creep experiments.
Micheal Younan +5 more
wiley +1 more source
Analysis of Average Power Tracking Doherty Power Amplifier
An average power tracking (APT) Doherty power amplifier (PA) is analyzed in terms of its biasing voltage condition, efficiency, and output power. And the drain and gate bias voltages are optimized for operation at different output power conditions.
Lee, J, Kim, S, Minn, D, Kim, B, Park, Y
core +1 more source
Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang +10 more
wiley +1 more source

