Results 111 to 120 of about 7,149 (147)
Some of the next articles are maybe not open access.
KSME International Journal, 2004
This paper reports an experimental study on flow boiling of pure refrigerants R134a and R123 and their mixtures in a uniformly heated horizontal tube. The flow pattern was observed through tubular sight glasses with an internal diameter of 10 mm located at the inlet and outlet of the test section.
Tae Woo Lim, Jun Hyo Kim
openaire +1 more source
This paper reports an experimental study on flow boiling of pure refrigerants R134a and R123 and their mixtures in a uniformly heated horizontal tube. The flow pattern was observed through tubular sight glasses with an internal diameter of 10 mm located at the inlet and outlet of the test section.
Tae Woo Lim, Jun Hyo Kim
openaire +1 more source
Microemulsion Formation in 1,1,1,2-Tetrafluoroethane (R134a)
Langmuir, 2003Water solubilization by anionic perfluorinated surfactants has been examined in the condensed phase of the hydrofluorocarbon (HFC) gas 1,1,1,2-tetrafluoroethane (R134a) in the temperature range 15-55 °C and to pressures of 500 bar. The surfactant di(1H,1H,5H-octafluoro-n-pentyl) sodium sulfosuccinate (di-HCF4) forms stable water-in-R134a microemulsions
David C. Steytler +4 more
openaire +1 more source
EXPERIMENTAL STUDY ON R1234yf/R134a MIXTURE (R513a) AS R134a REPLACEMENT IN HEAT PIPES
Journal of Enhanced Heat TransferWe compare the efficacy of R513a, a refrigerant blend comprising hydrofluorocarbon/hydrofluoroolefin, with R134a, a commonplace refrigerant having a higher global warming potential, in the context of low-temperature heat pipe applications. Tests were conducted considering both helically grooved heat pipes and also smooth heat pipes (i.e., thermosyphons)
Vivek Kumar +4 more
openaire +1 more source
Journal of Heat Transfer, 2008
Abstract Local heat transfer coefficients for flow boiling of pure 1,1,1,2-tetrafluoroethane (R134a) and binary mixtures of propane (R290) and R134a were measured. The experimental setup employed a vapor heated plain horizontal tube (di=10mm, do=12mm, L=500mm). The measurements covered a wide range of saturation temperatures (233≤Ts≤278K)
A. Rabah, S. Kabelac
openaire +1 more source
Abstract Local heat transfer coefficients for flow boiling of pure 1,1,1,2-tetrafluoroethane (R134a) and binary mixtures of propane (R290) and R134a were measured. The experimental setup employed a vapor heated plain horizontal tube (di=10mm, do=12mm, L=500mm). The measurements covered a wide range of saturation temperatures (233≤Ts≤278K)
A. Rabah, S. Kabelac
openaire +1 more source
Advanced Materials Research, 2012
A general air-source heat pump water heater originally designed to work with R134a was reconstructed as experimental rig for performance studies on systems using different refrigerants including R32, R134a and the mixture of R32/R134a which mass ratio is 1:5.
De Feng Ding +4 more
openaire +1 more source
A general air-source heat pump water heater originally designed to work with R134a was reconstructed as experimental rig for performance studies on systems using different refrigerants including R32, R134a and the mixture of R32/R134a which mass ratio is 1:5.
De Feng Ding +4 more
openaire +1 more source
Transport properties of 1,1,1,2-tetrafluoroethane (R134a)
International Journal of Thermophysics, 1993New equations for the thermal conductivity and the viscosity of R134a that are valid in a wide range of pressures and temperatures are presented. They were obtained through a theoretically based, critical evaluation of the available experimental data, which showed considerable inconsistencies between data sets, in particular in the vapor phase.
R. Krauss +3 more
openaire +1 more source
Solubility measurements of R134a in nanolubricant
2014In the last years, the employment of hydrofluorocarbons (HFCs) in Heating, Ventilating, Air Conditioning and Refrigeration (HVACR) applications has gained a big increase, due to the necessity to substitute the old chlorinated refrigerants. However, HFCs are not compatible with the mineral oils (MO), widely used in the past.
M Scattolini +4 more
openaire +3 more sources
Surface tension of refrigerants R123 and R134a
Journal of Chemical & Engineering Data, 1990Les tensions superficielles des solutions de dichloro-2,2 trifluoro-1,1,1 ethane (R123) et de tetrafluoro-1,1,1,2 ethane (R134a) sont mesurees en fonction de la ...
Hee Baik Chae +2 more
openaire +1 more source
Absorption system based on the refrigerant R134a
International Journal of Refrigeration, 1995The possibility of using 1,1,1,2-tetrafluoroethane (R134a) as a refrigerant in combination with different organic absorbents, such as dimethylether tetraethyleneglycol (DMETEG), N-methyl ϵ-caprolactam (MCL) or dimethyl-ethyleneurea (DMEU), in absorption units was investigated.
I Borde, M Jelinek, N.C Daltrophe
openaire +1 more source
Viscosity of R134a, R32, And R125 at Saturation
International Journal of Thermophysics, 1999This paper reports the results of the measurement of the viscosity of R134a close to the saturation line in the vapor phase. The new measurements were carried out in a vibrating-wire viscometer specially constructed for the purpose, and the results have an accuracy of ±2%.
C. M. B. P. Oliveira, W. A. Wakeham
openaire +1 more source

