Gas-holdup in a 16.6 cm I.D. reciprocating plate column [PDF]
The effects of operation conditions (the vibration intensity and gas flow rate) on the gas holdup in a 16.6 cm i.d. two-phase reciprocating plate column (RPC) were studied.
Vasić Ljubiša S. +4 more
doaj +5 more sources
The reciprocating plate column is a kind of column with the plates driven by a geared motor, and it has advantages in regard to efficiency compared to traditional columns in the extraction process, however, it comes with an increase in energy consumption.
Kai Guo +6 more
doaj +4 more sources
Gas hold-up in a three-phase reciprocating plate column [PDF]
The influence of the geometry of a reciprocating plate column (diameter), superficial gas velocity, vibration intensity and content of the solid phase in the column on the gas hold-up in a three phase column (G–L–S) were investigated in this study.
LJUBISA B. NIKOLIC +3 more
doaj +5 more sources
Oxygen mass transfer in a 16.6 cm i. d. multiphase reciprocating plate column [PDF]
The effects of vibration intensity, superficial gas velocity and content of solid particles on the volumetric oxygen mass transfer coefficient (k1a) in a 16.6 cm i.d. multiphase reciprocating plate column were strudied.
LJUBISA S. VASIC +4 more
doaj +5 more sources
The gas holdup in a multiphase reciprocating plate column filled with carboxymethylcellulose solutions [PDF]
Gas holdup was investigated in a gas-liquid and gas-liquid-solid reciprocating plate column (RPC) under various operation conditions. Aqueous carboxymethyl cellulose (sodium salt, CMC) solutions were used as the liquid phase, the solid phase was spheres ...
Stamenković Ivica S. +5 more
doaj +4 more sources
Effects of Rashig rings placed in interplate spaces and the rheological properties of the liquid phase on power consumption in a gassed reciprocating plate column [PDF]
The power consumption in a gassed reciprocating plate column with Rashig rings placed in interplate spaces increases with both increasing vibration intensity and content of solid particles but decreases with increasing the superficial gas velocity ...
Aleksić Mirko Đ. +4 more
doaj +2 more sources
A new type of an assembled monolithic concrete column encased by partial outsourcing steel was proposed, and the seismic performance was proposed. To study the seismic performance such as failure mode, hysteretic behavior, deformation, ductility of the ...
Y. L. Wang, X. Y. Wu, B. B. Li
doaj +2 more sources
Seismic Behavior of T-Shaped Concrete-Filled Steel Tubular Column to Steel Beam Joints with Side Plates [PDF]
This study investigates the seismic behavior of the T-shaped concrete-filled steel tubular (CFST) column to steel beam joints, aimed at expanding their applicability in areas with high-seismic fortification intensity. A construction form of T-shaped CFST
Jinyan Wang +5 more
doaj +3 more sources
Study on seismic behavior of reinforced concrete column-steel beam side joints
In this paper, a steel beam insert RCS side joint specimen is designed, and the low-cycle reciprocating loading test has been studied by designing a similar form of side joint specimen.
Yuhong Ling +4 more
doaj +2 more sources
Axial dispersion of the liquid phase on a three-phase Karr reciprocating plate column [PDF]
The influence of the gas flow rate and vibration intensity in the presence of the solid phase (polypropylene spheres) on axial mixing of the liquid phase in a three phase (gas-liquid-solid) Karr reciprocating plate column (RPC) was investigated. Assuming
Nikolić Ljubiša B. +4 more
doaj +2 more sources

