Results 121 to 130 of about 2,034 (287)
steel research international, EarlyView.This study validates a recycling pathway for converting interconnect assemblies from end‐of‐life SOC stacks into commercial‐grade AISI 304 steels. Using scrap‐based steelmaking operations, austenitic cast steels with <4.0% δ‐ferrite are successfully produced.
Jeraldine Lastam +7 more
wiley +1 more source
Evaluating Plasma Torches as a Low‐Decarburization Preheating Method for MgO–C Refractory Linings
steel research international, EarlyView.This study evaluates direct current (DC) plasma torches using nitrogen as an alternative preheating method for magnesia‐carbon (MgO–C) refractory‐lined ladles. Full‐scale trials at 0.7 and 1.5 MW are compared to conventional gas burner. Plasma‐heated samples show lower decarburization and improved surface integrity due to partial sintering and reduced ...
Marcus Holmström +3 more
wiley +1 more source
Development and Testing of Castables with Low Content of Calcium Oxide. [PDF]
Materials (Basel), 2022 Zemánek D, Nevřivová L.
europepmc +1 more source
Development of a High Temperature Heater using an Yttria Stabilized Zirconia Cored Brick Matrix [PDF]
The Ames pilot heater is a ceramic regenerative heater that provides high temperature air for aerodynamic and combustion experiments. The development of this heater to provide a heat storage bed with temperature capability of about 4600 R is described. A
Decoursin, D. G., Smith, K. W.
core +1 more source
steel research international, EarlyView.This study develops a thermodynamic–kinetic model for basic oxygen furnace tapping and validates its accuracy under near‐equilibrium and far‐from‐equilibrium initial conditions. Comparison with a reference model demonstrates its broader applicability. The model further reveals the evolution of key steel and slag components, providing new transparency ...
Puhong Cheng +4 more
wiley +1 more source
Prolonging Campaign Life of Blast Furnace Trough by Water Cooling. [PDF]
Materials (Basel), 2023 Li Z, Wang H, Ding F, Tang H.
europepmc +1 more source
steel research international, EarlyView.The study presents a dynamic zonal model for hydrogen plasma smelting reduction (HPSR) in direct current arc furnaces, predicting time‐dependent behavior of metal, slag, and off‐gas. The study considers various industrial scenarios to quantify energy demand, hydrogen utilization, degree of reduction, and other operational sensitivities.
Tristan K. Wickham +4 more
wiley +1 more source
High Temperature Concrete / Monolithics For Application In Kiln And Furnace: Role Of Chemistry [PDF]
, 2016 The conventional high temperature concrete for application in kiln and furnaces is a mixture of refractory aggregate and calcium aluminate cement binder.
DAS, Swapan Kumar
core
Utilisation of fly ash in insulating castable refractory
, 2001 Environmental Management Division, Central Fuel Research Institute, P.O. F.R.I., Dhanbad-828 108, India Manuscript received 21 February 2000, revised 30 August 2000, accepted 22 December 2000 Utilisation of fly ash as a raw material for making insulating castable refractory has been explored.
S. Maitra +3 more
openaire +1 more source