Results 11 to 20 of about 277,643 (298)
Yb:CALYO-based femtosecond chirped pulse regenerative amplifier for temporally resolved pump-probe spectroscopy [PDF]
Diode-pumped femtosecond chirped pulse regenerative amplifiers based on Yb3+-materials are of practical importance for wide range of scientific, industrial and biomedical applications.
A. S. Rudenkov +5 more
doaj +2 more sources
Broadband regenerative amplifier based on Ho:CALGO at 2.1 μm [PDF]
We present a broadband Ho:CALGO regenerative amplifier operating at 2.1 μm, delivering a pulse energy of 342 μJ at 1 kHz with a spectral bandwidth of 5 nm, supporting sub-ps pulse duration.
Suzuki Anna +4 more
doaj +2 more sources
20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier. [PDF]
This is a report on a 100 W, 20 mJ, 1 ps Yb:YAG thin-disk regenerative amplifier. A homemade Yb:YAG thin-disk, Kerr-lens mode-locked oscillator with turn-key performance and microjoule-level pulse energy is used to seed the regenerative chirped-pulse ...
Alismail A, Wang H, Brons J, Fattahi H.
europepmc +2 more sources
Regenerative Nd:glass amplifier seeded with a Nd:fiber laser [PDF]
Wavelength tuning and broad-bandwidth operation of a passively mode-locked Nd:fiber laser is demonstrated at 1060 microm. The oscillator pulses are used to seed a bulk regenerative Nd:glass amplifier, and 300-fs transformlimited pulses with an energy of 10 microJ are obtained after 31 round trips at a repetition rate of 500 Hz.
Hofer, M. +5 more
openaire +5 more sources
Simulation of a regenerative MW FEL amplifier [PDF]
Both oscillator and regenerative amplifier configurations are being studied to optimize the design of a MW-class FEL. The regenerative amplifier uses a longer undulator and relies on higher extraction efficiency to achieve high average power, whereas the
Wong, R.L. +3 more
core +7 more sources
Indirectly LED-pumped Nd:glass regenerative amplifier
We demonstrate the first LED-pumped Nd:glass regenerative amplifier. It delivers 2 ns pulses at 1053 nm with an energy of 3.8 mJ at a repetition rate of 2 Hz. This performance is achieved using a Ce:LuAG luminescent concentrator producing 3.4 kW of optical peak power in the yellow spectral range and pumped by 3200 blue LEDs.
Nourry-Martin, Maxime +7 more
openaire +4 more sources
A High-Energy, 100 Hz, Picosecond Laser for OPCPA Pumping
A high-energy diode-pumped picosecond laser system centered at 1064 nm for optical parametric chirped pulse amplifier (OPCPA) pumping was demonstrated. The laser system was based on a master oscillator power amplifier configuration, which contained an Nd:
Hongpeng Su +5 more
doaj +1 more source
Diode-pumped regenerative Yb:SrF2 amplifier [PDF]
International audienceWe report what we believe to be the first Yb:SrF2 regenerative femtosecond amplifier. The regenerative amplifier produces 325-fs pulses at 100-Hz repetition rate with an energy before compression of 1.4 mJ.
Druon, Frédéric +15 more
core +1 more source
LED-pumped femtosecond Cr:LiSAF regenerative amplifier system
International audienceWe report on the first, to the best of our knowledge, LEDpumped femtosecond regenerative amplifier. It is based on a Cr:LiSAF crystal pumped by 2240 blue LEDs via a Ce:YAG luminescent concentrator. The amplifier was seeded by pulses
Balembois, François +4 more
core +1 more source
Three-Dimensional, Time-Dependent Analysis of High- and Low-Q Free-Electron Laser Oscillators
Free-electron lasers (FELs) have been designed to operate over virtually the entire electromagnetic spectrum, from microwaves through to X-rays, and in a variety of configurations, including amplifiers and oscillators. Oscillators can operate in both the
Peter J. M. van der Slot +1 more
doaj +1 more source

