Results 121 to 130 of about 1,606 (256)
steel research international, EarlyView.This work investigates the wear resistance and nitriding behavior of PBF‐LB/M‐processed Osprey HWTS 50, a lean hot work tool steel. Three heat treatment conditions are compared to conventional wrought H13, H11, and PBF‐LB/M 18Ni300. The study highlights HWTS 50's enhanced nitrogen diffusion, deeper nitriding hardness depth, and comparable or improved ...
Jonathan Hann +6 more
wiley +1 more source
In Situ Alloying of H13 Tool Steel With TiC via PBF‐LB/M
steel research international, EarlyView.H13 tool steel is in situ alloyed with titanium carbides (TiC) in amounts up to 30 wt.%. This approach offers the advantage that the carbides melt only partially during processing, preventing excessive carbon enrichment of the steel matrix. The resulting microstructure consists of coarse, undissolved and fine, reprecipitated carbides, leading to grain ...
Oliver Bürgi +2 more
wiley +1 more source
Stabilization of Retained Austenite in Nickel Steels
Journal of the Japan Institute of Metals, 1970 Hajime Suto, Takeo Yamagata
openaire +2 more sources
Exploiting Residual Elements Arising from Scrap Steel in Future Sustainable Steel Alloy Design
steel research international, EarlyView.Herein, the effects of residual elements Cu and Sn on grain growth, recrystallization, and phase transformation in C–Mn steel are summarized, and a case study is presented on how the presence of residual elements can be exploited to reduce deliberate Nb microalloying while achieving the same grain size control and strength during thermomechanical ...
Claire Davis +5 more
wiley +1 more source
The Mossbauer spectroscopy studies of retained austenite [PDF]
, 2007 Purpose: of this paper: This paper completes the knowledge concerning the mechanisms of destabilization and properties of retained austenite.
Krawczyk, J. +2 more
core
Microstructure, Defects, and Fatigue Response of High‐Strength Tool Steels
steel research international, EarlyView.The martensitic tool steel family is designed for use in various working environments where they are subjected to repeatedly high mechanical loads. Despite the continuous upgrade of material´s microstructures through compositional development or processing techniques, defects remain a critical factor for the tool performance by leading to fatigue ...
Katerina Chantziara +3 more
wiley +1 more source
steel research international, EarlyView.Heat treatments that alter the proportions of austenite and ferrite phases or induce the precipitation of phases such as sigma in duplex stainless steel UNS S32205 make it more susceptible to pitting and crevice corrosion. However, the effects of these treatments are not always evident when analyzed using the cyclic polarization technique.
Alba Regina Turin +8 more
wiley +1 more source
, 2001 Morphology and stability of retained austenite in thermomechanically processed C-Mn-Si (-Nb) trip ...
Ilana Timokhina (13055427) +2 more
core
, 2019 A microstructure evolution of the thermomechanically processed 3Mn-1.5Al type steel and mechanical stability of retained austenite were investigated during interrupted tensile tests.
Adam Grajcar +3 more
core +1 more source
steel research international, EarlyView.Laser powder bed fusion of JIS SKD61 tool steel is systematically optimized using a Taguchi design and ANOVA. Hatch spacing and layer thickness are identified as dominant parameters controlling surface roughness and tensile strength. Subsequent tempering at 600°C improves microstructural stability and mechanical performance, enabling high‐density SKD61
Masrurotin Masrurotin +4 more
wiley +1 more source