Results 31 to 40 of about 10,082 (264)
Simulation and Research on deep rolling process parameters [PDF]
International Journal of Advanced Design and Manufacturing Technology, 2012 Deep rolling is a kind of mechanical surface treatments that can improve surface quality, dimensional accuracy and mechanical properties of the parts. Compressive residual stresses generated by the process reduce the tensile stresses during loading into ...
kianoush alasvand
doaj
Advanced Engineering Materials, EarlyView.Additive manufacturing provides precise control over the placement of continuous fibres within polymer matrices, enabling customised mechanical performance in composite components. This article explores processing strategies, mechanical testing, and modelling approaches for additive manufactured continuous fibre‐reinforced composites.
Cherian Thomas, Amir Hosein Sakhaei
wiley +1 more source
Advanced Engineering Materials, EarlyView.This plot compares experimental tensile stress–strain curves (with 4 different strain rates) and corresponding modelled curves (obtained using the optimised sets of Voce and Miller–Norton parameter values shown). The inferred M‐N values, characterizing the creep, are very similar to those obtained via conventional creep testing.
S. Ooi, R. P. Thompson, T. W. Clyne
wiley +1 more source
Rolling friction and bistability of rolling motion
, 2005 The rolling motion of a rigid cylinder on an inclined flat viscous surface is investigated and the nonlinear resistance force against rolling, $F_R(v)$, is derived. For small velocities $F_R(v)$ increases with velocity due to increasing deformation rate of the surface material.
Poeschel, Thorsten +3 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver +9 more
wiley +1 more source
Jixie qiangdu, 2017 In this paper,we study the rolling friction of the triangular tooth friction wheel and the flexible track under the condition of small deformation contact. According to the Crook ’s elastic plastic rolling friction theory,the flexible rail is established
ZHANG ZhiChen +5 more
doaj
FrictionFriction energy consumption is the primary cause of energy loss in rolling bearings, and friction characteristics are critical indicators of rolling bearing quality.
Panlong Wu +5 more
doaj +1 more source
A Dislocation Perspective on Strength and Toughness in Ceramics
Advanced Engineering Materials, EarlyView.Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley +1 more source
Dynamics of a Rolling Disk in the Presence of Dry Friction [PDF]
Journal of Nonlinear Science, 2005 ISSN:1432 ...
Cédric Le Saux +2 more
openaire +2 more sources
Electrified Damage in Motion Systems
Advanced Engineering Materials, EarlyView.The electrified damage in motion systems is a fundamental framework presenting the degradation pathway arising from the coupling of electrical energy transport with mechanical contact and interfacial chemistry. The framework positions electrified damage as a distinct degradation regime with unique characteristic surface morphologies and failures of ...
M. Humaun Kabir +2 more
wiley +1 more source