Results 11 to 20 of about 7,326 (250)
Rolling shear strength of timber boards
Bulletin of Kharkov National Automobile and Highway University, 2020 Abstract. Problem Rolling shear strength and rolling shear modulus are important mechanical and elastic properties that have emerged recently and are needed when calculating multi-storey CLT buildings. Goal Rolling shear is a new task that requires determining the influencing factors on it’s magnitude as an indicator of the strength of the boards in ...
Bidakov, Andrii +3 more
openaire +3 more sources
Frontiers in Physiology, 2021 A single use of a vibration foam roller likely increases the range of motion (ROM) without decreasing muscle strength and athletic performance. However, to date, no study compared the effects of a vibration roller with and without rolling on various ...
Masatoshi Nakamura +8 more
doaj +1 more source
Texture, Microstructure and Mechanical Properties of 6111 Aluminum Alloy Subject to Rolling Deformation [PDF]
Materials Research, 2017 The mechanical properties, texture and microstructural evolution of a 6111 aluminum alloy during hot rolling and cold rolling deformation were systematically investigated in this article.
Lixin Zhang +6 more
doaj +1 more source
Metals, 2020 The effect of rolling temperatures on the interface microstructure and mechanical properties is investigated using 2-mm-thick TA1/Q235B composite sheets, which were prepared after nine passes of hot rolling of explosive welded plates.
Huizhong Li +6 more
doaj +1 more source
Journal of Materials Research and Technology, 2023 6061 aluminum (Al) alloys were asymmetrically rolled to apply shear deformation, and the effects of pre/post-aging treatment on the mechanical properties and texture evolution were analyzed.
Wonkee Chae +8 more
doaj +1 more source
Structural Properties of Commercial Australian Plantation Hardwood CLT
Buildings, 2023 Significant volumes of plantation hardwood are available in Australia to produce value-added engineered wood products such as cross-laminated timber (CLT).
Mateo Gutierrez +3 more
doaj +1 more source
Evaluation of rolling shear strength of plywood by flexural vibration method
Journal of Wood Science, 1998 The rolling shear strength of plywood was evaluated using a flexural vibration test. Test specimens were lauan and Douglas fir three-ply plywoods made from thick veneers. The dynamic shear and Young's moduli were determined using the flexural vibration method, which involved in-plane and out-of-plane flexural vibration.
Heng Xu +4 more
openaire +1 more source
Journal of Materials Research and Technology, 2023 Cu/Al corrugated laminated composites were prepared by corrugated cold roll bonding (CCRB), and the deformation behavior and bonding properties of the laminated composites were investigated by experimental research and numerical simulation.
Gao Xiangyu +5 more
doaj +1 more source
Microstructure and bonding properties of hot-rolled 7075/AZ31B clad sheets
工程科学学报, 2020 Magnesium/aluminum (Mg/Al) bimetallic laminated composites have attracted considerable attention because of their excellent properties. Mg alloys are lightweight structural metals with low density and excellent properties such as high stiffness-to-weight
Zong-he WU +4 more
doaj +1 more source
Dimerization of a selectin and its ligand stabilizes cell rolling and enhances tether strength in shear flow [PDF]
Proceedings of the National Academy of Sciences, 2001 Selectins mediate rolling of leukocytes by rapid formation and dissociation of selectin–ligand bonds, which are assumed to require high mechanical strength to prevent premature dissociation by the forces applied in shear flow. This assumption is based largely on the observation that increasing wall shear stress increases only modestly the dissociation ...
V, Ramachandran +7 more
openaire +2 more sources