Results 21 to 30 of about 1,599 (162)

Wear behavior of PTFE-coated continuous alumina fiber sewing thread

Journal of Aeronautical Materials
Combined with sizing and two-dimensional knitting technology，continuous alumina fiber sewing threads with partial covering structures of F-3，F-4 and F-5 were prepared，and the effect of covering structure on the wear behavior between sewing threads and ...
MENG Ying, WU Ning, YUAN Zhiqing, ZHANG Yifan, CHEN Li   +4 more
doaj   +1 more source

FLEXIBLE PANEL ASSEMBLY TECHNIQUES USED IN THE CONSTRUCTION OF AERODYNAMIC DECELERATOR [PDF]

Annals of the University of Oradea: Fascicle of Textiles, Leatherwork, 2022
A combat aircraft is stabilized by the parachute during its dangerous maneuvers such as spin, loss of speed (at low angles of incidence), vibration of the wings (at very high speeds).
JOMIR Mihaela, SALISTEAN Adrian, BADEA Ionela, VLADU Alina   +3 more
doaj  

Optimization of Lubrication Amount for Sewing Threads

Textiles
Sewing needle heating is a common problem for the sewing of technical and medical textiles. The hot needle causes burnt spots on fabric, breakage of the thread, and weak seam strength.
Adnan Mazari, Funda Buyuk Mazari
doaj   +1 more source

SEWING THREADS AND THEIR TYPES

, 2023
There are many types of yarns with different properties. These are pure spun yarns made directly or from various types of staple fibers, mixed yarns made from several fibers, and filament yarns made from tows by direct twisting. may be threads. In general, it can be classified according to raw material, yarn diameter, spinning method, spinning system ...
openaire   +1 more source

SPUN SILK SEWING THREAD COUNTS [PDF]

Textile Institute. Journal. Proceedings and Abstracts, 1911
n ...
openaire   +1 more source

Systematic Investigation on the Mechanisms for Water Responsive Actuation Using Commercial Sewing Threads

Journal of Natural Fibers, 2023
Water-responsive materials alter their volumes in response to relative humidity changes. Recent progress in water-responsive materials demonstrates that this novel category of materials can perform better than natural muscles and conventional actuators ...
Junghwan Lee, Yaewon Park
doaj   +1 more source

The responses of stitched ultra-high-molecular-weight polyethylene woven fabrics upon ballistic impact

Journal of Industrial Textiles, 2022
This paper investigates the influence of thread stitching on the ballistic performance of plain weaves made of ultra-high-molecular-weight polyethylene multi-filament yarns.
Yi Zhou, Song Ding, Zhongwei Zhang, Ziming Xiong, Jiuxiao Sun, Xin Liu   +5 more
doaj   +1 more source

Influence of sewing parameters on the skin–fabric friction

AUTEX Research Journal
The mechanical properties of seaming stitch have been frequently reported. However, the frictional characteristics of seaming stitch have long been ignored.
Sun Guangwu, Li Guanzhi, Dong Dongdong, Hu Hongyan, Li Chulin   +4 more
doaj   +1 more source

The Quilt Speaks: Crafting Gender and Cultural Norms in Hawaii

Art/Research International, 2019
When protestant missionaries first arrived in Hawaii in the early nineteenth century one of their first concerns was the nudity of the indigenous population and the introduction of cloth and sewing was an early priority.
Una Kimokeo-Goes
doaj   +1 more source

Predicted sewing thread consumption using neural network method based on the physical and structural parameters of knitted fabrics

AUTEX Research Journal
This article presents an experimental study on the influence of various parameters on sewing thread consumption. Four knitted samples, featuring different structures and thicknesses, were tested by sewing two- and three-layer using chain stitch type 401.
Khedher Faouzi, Hamdi Thouraya, Jaouachi Boubaker, Jmali Mohamed   +3 more
doaj   +1 more source