Results 21 to 30 of about 86,938 (346)
Buck Inverter without Shoot through
A new buck inverter without shoot‐through problem is presented and analysed in this study. The traditional dual‐buck inverter has been proposed to solve the shoot‐through problem of bridge‐type inverters, eliminate the dead‐time effect and improve the reliability along with the conversion efficiency. However, the existing dual‐buck inverter is prone to
Feng Hong +4 more
openaire +1 more source
Z-source Neutral Point Clamped (NPC) inverter is a converter topology that combines the benefits of both the impedance network by storing temporary energy released to the load for voltage boosting and NPC inverter by guaranteeing lower Total Harmonic ...
Samir Noui +5 more
doaj +1 more source
Common bean is considered a recalcitrant crop for in vitro regeneration and needs a repeatable and efficient in vitro regeneration protocol for its improvement through biotechnological approaches.
Muhammad Aasim +11 more
doaj +1 more source
Analysis and mitigation of dead time harmonics in the single-phase full-bridge PWM converters with repetitive controllers [PDF]
In order to prevent the power switching devices (e.g., the Insulated-Gate-Bipolar-Transistor, IGBT) from shoot through in voltage source converters during a switching period, the dead time is added either in the hardware driver circuits of the IGBTs or ...
Blaabjerg, Frede +3 more
core +3 more sources
Improving culture initiation of mature oak shoots through use of silver thiosulfate
AbstractPremiseOf the approximately 430 species of oaks (Quercus spp.) that have been assessed, 31% are threatened with extinction and in need of safeguarding. However, oak seeds cannot be seed banked, and thus rely on alternative strategies such as in vitro culture for ex situ conservation.
Max Winkeljohn +2 more
openaire +3 more sources
Temperature and switching rate dependence of crosstalk in Si-IGBT and SiC power modules [PDF]
The temperature and dV/dt dependence of crosstalk has been analyzed for Si-IGBT and SiC-MOSFET power modules. Due to a smaller Miller capacitance resulting from a smaller die area, the SiC module exhibits smaller shoot-through currents compared with ...
Alatise, Olayiwola M. +5 more
core +1 more source
Maximum Power Point Tracking (MPPT) technique is used to extract maximum power from the photovoltaic system. This paper involves working on an enhanced Particle Swarm Optimization (PSO) based MPPT method for the photovoltaic (PV) system integrated ...
Kalaiarasi N. +4 more
doaj +1 more source
Micropropagation protocol for Stevia rebaudiana through axillary shoot proliferation
The present investigation was carried out at Anand Agricultural University, Gujarat during the year 2016 to develop a micropropagation protocol for mass multiplication of medicinally rich stevia plants.
BALRAM SINGH +5 more
doaj +1 more source
A Fault-Tolerant T-Type Multilevel Inverter Topology With Increased Overload Capability and Soft-Switching Characteristics [PDF]
he performance of a novel three-phase four-leg fault-tolerant T-type inverter topology is introduced in this paper. This inverter topology provides a fault-tolerant solution to any open-circuit and certain short-circuit switching faults in the power ...
Demerdash, Nabeel +4 more
core +2 more sources
Crosstalk in SiC power MOSFETs for evaluation of threshold voltage shift caused by bias temperature instability [PDF]
Threshold voltage drift from Bias Temperature Instability is known to be a reliability concern for SiC MOSFETs. Negative bias temperature instability (NBTI) results from positive charge trapping at the gate dielectric interface and is more problematic in
Alatise, Olayiwola M. +1 more
core +1 more source

