Results 111 to 120 of about 4,044 (168)

Compressive Split Hopkinson Pressure Bar (SHPB)

open access: yes, 2010
The intent of this report is to allow the reader has a clear idea and concept with the theory and technique applied on the Split Hopkinson Pressure Bar (SHPB).
Kam, Jihao
core  

Formation of Ramped Incident Wave in the SHPB Method

open access: yesJournal of the Society of Materials Science, Japan, 2018
openaire   +2 more sources

Ø100mm SHPB Equipment and its Application

open access: yesApplied Mechanics and Materials, 2011
Hopkinson Pressure Bar (HPB) is one of the main sets to study material dynamic mechanic properties. Large diameter HPB is mainly used for nonhomogeneous materials. In this paper the properties of Split Hopkinson Pressure Bar (SHPB) of Ø100mm are introduced, including its structure and performance index.
Zhi Gang Zhang   +4 more
openaire   +2 more sources

SHPB Experimental Investigation used for Concrete

open access: yesAdvanced Materials Research, 2011
The incident wave and transmission wave varying with the time have been obtained by SHPB experiment. The relationship curve for stress and strain of material concrete has also been obtained. The Weibull function is used to describe the damage factor of the concrete. The damage factor of the concrete changing with the time under the impact conditions is
Wei Zhang   +3 more
openaire   +2 more sources

Numerical Simulation of SHPB Experiment and Analysis on Stress Wave

open access: yesApplied Mechanics and Materials, 2011
Concrete is a typical kind of rate sensitive material. In this paper, the concrete specimens were tested in the SHPB experiment system. Based on H-J-C constitutive model, the SHPB experiment was simulated by LS-DANY. The stress-strain curves which were gat from numerical simulation in the LS-DANY were compared with the stress-strain curves which were ...
Ru Heng Wang   +3 more
openaire   +2 more sources

Enhancing performances of SHPB for determination of flow curves

open access: yesCIRP Annals, 2001
Abstract A compression test on a Split Hopkinson Pressure Bar (SHPB) is the most common testing method adopted to determine material flow curves in a quite wide range of high strain rates. However, in most ordinary SHPB applications material rheology can only be investigated up to a rather low strain.
BARIANI, PAOLO FRANCESCO   +2 more
openaire   +2 more sources

On the Errors Associated With the Use of Large Diameter SHPB, Correction for Radially Non-Uniform Distribution of Stress and Particle Velocity in SHPB Testing

International Journal of Impact Engineering, 2006
The large diameter (up to 100 mm) Split Hopkinson Pressure Bar (SHPB) setup is used throughout the world to test large-cell heterogeneous materials, small structures, etc. This paper proposes a correction method to take into account the non-uniform distribution of stress and particle velocity (non-plane wave effect) in large diameter setups, following ...
R. Merle, H. Zhao
exaly   +2 more sources

A Modified Method of Pulse-Shaper Technique Applied in SHPB

Composites Part B: Engineering, 2019
Abstract During the experimental measurement of solid materials by SHPB, a pulse-shaper technique is used to eliminate high-frequency oscillation components and acquire an incident pulse with a rising time that is greater than the time needed by the test specimen to reach a stress equilibrium state.
Shi Huan, Weijun Tao, Yijie Liu
exaly   +2 more sources

Strain-Rate Effect of Polymers and Correction Methodology in a SHPB Test

open access: yesInternational Journal of Impact Engineering, 2022
Split Hopkinson pressure bar (SHPB) has been commonly used to characterize the dynamic behavior of polymer at high strain-rates from 102 to 104 s−1. Based on numerical SHPB tests and Drucker-Prager model, this study examines the SHPB technique for the ...
Q M Li
exaly   +2 more sources

An SHPB Set-Up With Reduced Time-Shift and Pressure Bar Length

open access: yesInternational Journal of Impact Engineering, 2003
A modification of split Hopkinson pressure bar (SHPB) set-up based on wave separation technique is proposed in the present paper, which may be used to reduce the time-shifting distance and the pressure bar length in an SHPB test.
Q M Li
exaly   +2 more sources

Home - About - Disclaimer - Privacy