Results 121 to 130 of about 4,044 (168)

Study of stress wave propagation in SHPB with NHDMOC

open access: yesDYMAT 2009 - 9th International Conferences on the Mechanical and Physical Behaviour of Materials under Dynamic Loading, 2009
In this paper the NHDMOC method, which permits studying stress wave propagation with one dimensional strain, was applied to study the one-dimensional stress wave propagation. In this paper, the ZWT nonlinear visco-elastic constitutive relationship with 7
M. Xu   +4 more
openaire   +2 more sources

Experimental study for friction effect investigation on SHPB

open access: yes, 2001
The paper presents an investigation on SHPB behaviour used for material characterisation in compression testing at high strain rate. Material flow stress determined with the SHPB test is affected by radial and axial inertia as well as friction. The particular topics treated are the effects of friction between specimen and bars interfaces on the flow ...
BERTI, GUIDO   +2 more
openaire   +2 more sources

CORRECTION OF LATERAL INERTIA EFFECT IN SHPB

International Journal of Modern Physics B, 2008
A theoretical analysis of the stress state in specimen of the SHPB experiment was performed in consideration of lateral inertia effect. The nonuniformity of lateral stress in specimen and variety of deforming velocity in the loading process were taken into account in the analysis. A formula to correcting the lateral inertia effect was obtained.
CHEN GANG   +4 more
openaire   +1 more source

Strain rate design in SHPB test

SPIE Proceedings, 2009
A strain rate calculation formula of split Hopkinson pressure bar (SHPB) test is derived from one-dimensional stress wave propagation theory. According to the test conditions and specimen size, the test strain rate can be calculated by the formula; and the strain rate limitative range of SHPB test is analyzed.
Baojun Pang, Yao Zhu, Bingzheng Gai
openaire   +1 more source

Numerical modelling of SHPB splitting tests

Journal de Physique IV (Proceedings), 2003
The Splitting or Brazilian test of disks is a useful method to measure tensile strength on brittle materials. When the tensile stress reaches the tensile strength, the disk fails on the loading plane. Nevertheless, the stress state is not uniaxial, and the material undergoes compressive stresses, normal to the tensile ones.
F. Galvez, V. Sanchez Galvez
openaire   +1 more source

Temperature in high temperature SHPB experiments

Transactions of Tianjin University, 2008
As an experimental technique, it’s desired that the temperature in specimen is uniform in high temperature split Hopkinson pressure bar (SHPB) experiments. However, the temperature in specimen decreases and the temperature of bars increases when specimen starts to contact with bars, which induces the nonuniform temperature distribution in specimen, and
Zhifang Deng   +4 more
openaire   +1 more source

Study of Stress Wave Propagation in SHPB with NHDMOC

Applied Mechanics and Materials, 2013
In this paper the NHDMOC method which succeeded in studying stress wave propagation with one dimensional strain was applied to study the one-dimensional stress wave propagation. In this paper, the ZWT nonlinear visco-elastic constitutive relationship with 7 parameters to NHDMOC, and corresponding equations were deduced The equations was verified from ...
Ming Li Xu   +2 more
openaire   +1 more source

Investigation of the effects of transverse inertia on SHPB experiments

International Journal of Microstructure and Materials Properties, 2016
Due to the Poisson's effect, the effects of transverse inertia in specimen tested on Split Hopkinson Pressure Bar device are induced. Transverse inertia has been recognised as an important factor in dynamic responses of brittle materials. Contact friction generated at interfaces of the specimen and two pressure bars, can confine the dilation in the ...
C. Huang, Pan Wang, Lianqing Yu, Xi Liu
openaire   +1 more source

SHPB Dynamic Experiment on Silica Fume Concrete

Advanced Materials Research, 2013
Dynamic mechanical properties of silica fume concrete in a number of strain rate under the conditions of dynamic compression mechanical properties subjected to various strain rates were studied, and gained the stress versus strain curves, details of an experimental investigation using 74 mm-diameter split Hopkinson pressure bar(SHPB) apparatus were ...
Rong Jun Chen, Hong Wei Liu, Rui Zeng
openaire   +1 more source

STUDY OF SMALL DIMENSION SPECIMENS ON SHPB TEST

AIP Conference Proceedings, 2008
The feasibility and reliability of small dimension specimen SHPB tests were investigated by numerical simulation and experiments of 2024 aluminium alloy with series of dimension. Also an attempt is made to get curves of strain rate over 104 s−1 by small dimension specimens. Accuracy of transmitted signal in eccentric compression tests of small specimen
Dawu Xiao   +7 more
openaire   +1 more source

Home - About - Disclaimer - Privacy