Results 71 to 80 of about 45,706 (265)
Waveguide Geometry–Driven Trade‐Offs in Resonant Cavity Sensor Performance
Waveguide geometry governs the interplay between sensitivity, intrinsic Q‐factor, and wavelength noise in silicon nitride resonant sensors. Contrary to intuition, higher sensitivity does not ensure superior performance. Low‐noise, high‐Q ridge resonators achieve the lowest detection limits, revealing that detection is ultimately constrained by noise ...
Mohammad Talebi Khoshmehr +6 more
wiley +1 more source
On–Off Switchable Micromotors for Use in Steerable Microvehicles
Electrically controllable micromotors and microvehicles are developed by tuning the diffusion of the fuel. Self‐propelled micromotors using bubble propulsion show great promise for miniaturized devices with multiuse purposes such as cargo delivery and sensing. However, there is currently no method to electrically switch the micromotors on or off. Here,
Hugo Severinsson +3 more
wiley +1 more source
The influence of initial defects on mechanical stress and deformation distribution in oxidized silicon [PDF]
The near-surface silicon layers in silicon – dioxide silicon systems with modern methods of research are investigated. It is shown that these layers have compound structure and their parameters depend on oxidation and initial silicon parameters.
Kulinich O. A. +4 more
doaj
An introduction for multidrive and environment‐adaptive micro/nanorobotics: design and fabrication strategies, intelligent actuation, and their applications. Various intelligent actuation approaches—magnetic, acoustic, optical, chemical, and biological—can be synergistically designed to enhance flexibility and adaptive behavior for precision medicine ...
Aiqing Ma +10 more
wiley +1 more source
Temperature dependence of conductivity of silicon-silicon dioxide interface [PDF]
Abstract Conductivity of a silicon-silicon dioxide interface has been measured as a function of temperature. From the data the activation energies of the impurity levels introduced by the various ambient and heat treatments are estimated. Knowledge of surface charge density and carrier mobility is used to calculate the surface parameters.
openaire +2 more sources
Hard‐Magnetic Soft Millirobots in Underactuated Systems
This review provides a comprehensive overview of hard‐magnetic soft millirobots in underactuated systems. It examines key advances in structural design, physics‐informed modeling, and control strategies, while highlighting the interplay among these domains.
Qiong Wang +4 more
wiley +1 more source
Waveguide Photoactuators: Materials, Fabrication, and Applications
Waveguide photoactuators convert guided light into mechanical motion. Their tethered‐flexible design enables minimally invasive surgery and confined‐space robotics. This review aims to guide materials selection, device design, and system integration, accelerating the transition of waveguide photoactuators from laboratory prototypes to versatile ...
Minjie Xi +4 more
wiley +1 more source
Plastic deformation in nanostructure silicon formation [PDF]
The quantity and quality analysis of plastic deformation and near-surface silicon layers with nanostructure silicon formation are given in this paper.
V. A. Smyntyna +3 more
doaj +1 more source
Laser‐induced graphene (LIG) provides a scalable, laser‐direct‐written route to porous graphene architecture with tunable chemistry and defect density. Through heterojunction engineering, catalytic functionalization, and intrinsic self‐heating, LIG achieves highly sensitive and selective detection of NOX, NH3, H2, and humidity, supporting next ...
Md Abu Sayeed Biswas +6 more
wiley +1 more source
James CK Lai1, Gayathri Ananthakrishnan1,2, Sirisha Jandhyam1, Vikas V Dukhande1, Alok Bhushan1, Mugdha Gokhale1, Christopher K Daniels1, Solomon W Leung31Department of Biomedical and Pharmaceutical Sciences, College of Pharmacy and Biomedical Research ...
James CK Lai +3 more
doaj

