Results 11 to 20 of about 15,457 (271)
Effect of Local Recrystallized Grains on the Low Cycle Fatigue Behavior of a Nickel-Based Single Crystal Superalloy [PDF]
Crystals, 2019 This paper aims to understand the effect of local recrystallization (RX) on the low cycle fatigue fracture of a turbine-blade single crystal nickel-based superalloy.
Xianfeng Ma +4 more
doaj +2 more sources
Mechanical Engineering Journal, 2017 Fretting fatigue behavior of Ni-base superalloys used in gas turbine blades and disk assemblies have been investigated under ambient and high temperature conditions. A major emphasis was placed on the influence of experimentally measured tangential force
Balavenkatesh RENGARAJ +2 more
doaj +3 more sources
International Journal of Electrochemical Science, 2012 The influence of surface orientation on the oxidation resistance of Ni-based single crystal superalloy CM186LC at 1100°C in air was investigated. The specimens with (001) surface showed a higher oxidation rate value compared to the specimens with (011 ...
Fahamsyah H. Latief +2 more
doaj +2 more sources
Structure-property relations in superalloy single crystals
, 2016 This research is concerned with a single crystal nickel-base superalloy which has been developed for application as a high pressure turbine blade material in jet aircraft engines. The microstructures and mechanical properties of superalloys, including the effects of heat-treatments, have been reviewed.
Adrian A. Hopgood
openaire +3 more sources
The Effect of the Cooling Rates on the Microstructure and High-Temperature Mechanical Properties of a Nickel-Based Single Crystal Superalloy. [PDF]
Materials (Basel), 2020 Wang XY, Li M, Wen ZX.
europepmc +3 more sources
Vibration Fatigue Properties and Fracture Mechanism of DD6 Single Crystal Superalloy
Cailiao gongcheng, 2018 Room Temperature vibration fatigue S-N curves of single crystal superalloy DD6 with[001] orientation was investigated and room temperature vibration fatigue limit was obtained. The fracture mechanism was studied by OM, SEM and EBSD. The results show that
LIU Li-yu +3 more
doaj +1 more source
Journal of Materials Research and Technology, 2023 Joining single crystal superalloy with polycrystalline superalloy has important applications in the aerospace industry. Here, the IC10 single crystal superalloy to GH536 polycrystalline superalloy was diffusion brazed using a BNi-2 filler alloy.
Tong Wu +9 more
doaj +1 more source
The effect of thermal cycling on the high-temperature creep behaviour of a single crystal nickel-based superalloy [PDF]
, 2007 Isothermal and thermal cycling creep behaviours of a single crystal nickel-based superalloy have been studied by means of tensile tests at 1150 °C and 80 MPa.
Andrieu, Eric +3 more
core +2 more sources
Mechanisms of High Temperature Degradation of Thermal Barrier Coatings. [PDF]
, 2009 Thermal barrier coatings (TBCs) are crucial for increasing the turbine inlet temperature (and hence efficiency) of gas turbine engines. The thesis describes PhD research aimed at improving understanding of the thermal cycling failure mechanisms of ...
Wu, Rudder T.C., Wu, Rudder T.C.
core +1 more source
Thermomechanical fatigue in single crystal superalloys [PDF]
MATEC Web of Conferences, 2014 Thermomechanical fatigue (TMF) is a mechanism of deformation which is growing in importance due to the efficiency of modern cooling systems and the manner in which turbines and associated turbomachinery are now being operated. Unfortunately, at the present time, relatively little research has been carried out particularly on TMF of single crystal (SX ...
Moverare Johan J., Reed Roger C.
openaire +2 more sources