Results 141 to 150 of about 27,321 (196)
Structure of Slag (Review 1) : Basicity of Slag
Structure of Slag (Review 1) : Basicity of Slagopenaire +1 more source
Structure of Slag (III) : Structural problems on slag
Structure of Slag (III) : Structural problems on slagopenaire +1 more source
Viscosities of Iron Blast Furnace Slags
ISIJ International, 2014 The viscosities of the industrial and synthetic iron blast furnace slags have been measured using a custom designed rotating bob apparatus. This advanced apparatus enables control of the gas atmosphere and rapid quenching of the samples on completion of ...
Mingyin Kou, Baojun Zhao, Mao Chen
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Slag Melting Characteristic of Slag Forming and Slag Splashing for BOF Less Slag Smelting
Journal of Iron and Steel Research International, 2012The slag melting characteristic of slag forming and slag splashing for 300 t BOF less slag process is researched by combining the methods of the slag chemical composition, the melting point determination and the petrographie analysis. The results show that the melting point of final slag for less slag smelting is 20 ’C lower than that for conventional ...
Wei Wu +5 more
openaire +1 more source
Antonie van Leeuwenhoek, 1997
The potential of a Cu/Ni mining slag to act as a substrate for the growth of the bacteria Thiobacillus ferrooxidans, Thiobacillus thiooxidants, and Thiobacillus thioparus was examined. As well, slag and slag seepage samples were screened for the presence of the Thiobacillus species.
D W, Male, L G, Leduc, G D, Ferroni
openaire +2 more sources
The potential of a Cu/Ni mining slag to act as a substrate for the growth of the bacteria Thiobacillus ferrooxidans, Thiobacillus thiooxidants, and Thiobacillus thioparus was examined. As well, slag and slag seepage samples were screened for the presence of the Thiobacillus species.
D W, Male, L G, Leduc, G D, Ferroni
openaire +2 more sources
The influence of steel slag and ferronickel slag on the properties of alkali-activated slag mortar
Construction and Building Materials, 2019Abstract With the continuous development of industry, a huge amount of industrial wastes have been produced and caused severe environmental problems. In order to reduce the issue caused by industrial waste, in this investigation, 50 wt% ground granulated blast furnace slag (GGBS) replaced by steel slag (SS) or ferronickel slag (FNS) was used to ...
Nanqiao You +5 more
openaire +1 more source
Effect of Ladle Slag Modification on Slag Sticking to Snorkel and Rate of Slag Erosion
Advanced Materials Research, 2011To reduce the slag sticking to snorkel and to increase the operation life of snorkel during ladle alloying process, B2O3-CaO (mass ratio 1:2) and CaF2-CaO(mass ratio 1:2) were respectively employed as modifiers added to ladle slag. The effects of modifier on weight of sticking slag and erosion rate were investigated.
Hong Ming Wang +6 more
openaire +1 more source
Slag-Refractory Interaction in Slagging Coal Gasifiers
Materials Science Forum, 2008The combustion chamber of slagging coal gasifiers is lined with refractories to protect the steel shell of the gasifier from elevated temperatures and corrosive attack of the coal slag. Refractories composed primarily of Cr2O3 have been found most resistant to slag corrosion, but they continue to fail performance requirements.
Josef Matyas +4 more
openaire +1 more source
Consolidation of simulated slagging-pyrolysis-incinerator slags
Nuclear and Chemical Waste Management, 1983Abstract The methods of arc melting and inclusion in concrete were used to consolidate slagging-pyrolysis-inciner (SPI) slags. The SPI is a wet-bottom, modified vertical-shaft furnace being considered for processing low-level radioactive wastes into granulated slag and metal.
L.L. Oden, E.A. Johnson, P.E. Sanker
openaire +1 more source
Slag and hot-slag resistance of basic refractories
Refractories, 1968Using the instrument described, which has been improved in design for testing refractory materials for slag and hot slag resistance, we investigated the properties of magnesite, magnesite-chromite, and chrome-magnesite specimens. It was established that their life is determined by the resistance of the refractory bond.
P. S. Mamykin, I. D. Kashcheev
openaire +1 more source