Results 41 to 50 of about 27,321 (196)
Utilization possibilities of steel slag as backfill material in coastal structures
Scientific Reports, 2023 The aim of this study is to investigate the utilization possibilities of steel slags, basic oxygen furnace (BOF) and electric arc furnace (EAF) slags, as backfill material in coastal structures.
Gulsen Tozsin +3 more
doaj +1 more source
Assessment of Magnesia Refractories Corrosion by Iron-Rich Slags
Materials Proceedings, 2022 High purity magnesia refractories have been tested for their resistance to iron-rich converter slags of ferronickel production. Laboratory tests were performed using crucibles made from magnesia refractories filled with slag at temperatures up to 1700 °C
Konstantinos Betsis +3 more
doaj +1 more source
Slag Splashing: simulation and analysis of the slags conditions
Journal of Materials Research and Technology, 2019 The successful application of the repair and prevention of LD converters refractories technique called Slag Splashing requires a close control of the slag physicochemical properties (basicity, viscosity and surface tension), as well as suitable selection of operational parameters and geometric configurations.
Inamara Amanda Souza Santos +5 more
openaire +2 more sources
Stress relaxation behavior of molten slags
, 2006 In the present work, a method to measure stress relaxation of molten slags, developed earlier by one of the authors, was applied to mould flux slags as well as synthetic slags. The molten slag was sandwiched by two Pt plates and was compressed.
Matsushita, Taishi, +5 more
core +1 more source
, 2016 According to the experimental results of hot metal dephosphorization by CaO-based slags at a commercial-scale hot metal pretreatment station, activity of P2O5 in the CaO-based slags has been determined using the calculated comprehensive mass action ...
Duan, Dong-Ping +4 more
core +1 more source
The electrical conductivity of melter type slags [PDF]
, 2003 Bibliography: p. 219-226.This thesis details an investigation into the factors affecting the electrical conductivity of slags containing some or all of the following components: Ah03, cae, Cr203, FeOx, MgO and Si02.
Hundermark, Rodney
core +1 more source
Early Bronze Age copper smelting furnaces from Chrysokamino, Crete
UISPP Journal, 2023 During the Early Bronze Age, before the expansion in copper mining and distribution of this metal from Cyprus, Aegean metal production relied especially on local ores.
Philip P. Betancourt +2 more
doaj +1 more source
Review of comprehensive utilization of typical ferroalloy slags
工程科学学报, 2020 Three typical ferroalloy slags, namely, silicon–manganese, nickel–iron, and chrome–iron slags, are produced in large quantities as by-products. This is because they are not efficiently utilized, which creates lots of pressure on environmental capacity ...
Xi-wang MIAO +6 more
doaj +1 more source
On the Viscosities of Molten Slags. I : Viscosities of CaO-SiO_2-Al_2O_3 Slags [PDF]
, 2010 application/pdfViscosities of synthetic CaO-SiO_2-Al_2O_3 slags were measured by rotating inner-cylinder viscosimeter, and iso-viscosity lines at 1, 500 and 1, 600℃ are drawn on the diagram.
KAWAI, Yasuji, SAITO, Tunezo
core +1 more source
Hydraulic properties of ladle slags [PDF]
, 2016 The article presents results of examining of hydraulic properties of ladle slags formed during production of steel. The studied ladle slags were subjected to different cooling mode from the molten state.
Topinková, M. +23 more
core +1 more source