Results 61 to 70 of about 30,399 (295)
Utilization of metallurgical slags in the construction materials production [PDF]
Utilization methods of metallurgical slags, the list of products obtained on the basis of blast furnace slags and benefits from slags utilization are presented.В работе рассмотрены способы утилизации металлургических шлаков, перечень продуктов ...
Гумирова, Е. С. +3 more
core
Corrosion phenomena between refractories and steel slags
Corrosion phenomena between refractories and steel ...
REYNAERT Camille (8121680) +5 more
core +1 more source
Synthesis and characterization of sugarcane bagasse‐derived activated carbon via KOH‐assisted dry and wet activation. ABSTRACT This study explores the impact of activation processes on the morphological properties of activated carbon. Carbon is initially produced through vacuum pyrolysis at three temperatures (500°C, 600°C, and 700°C), with a heating ...
Sachin Channappa Hallad +5 more
wiley +1 more source
Microstructural characterisation of chromium slags [PDF]
In this chromium slags that form during melting of chromium alloyed steels are examined. During melting and oxidation of these steel grades a considerable amount of chromium is lost, and gained back with slag reduction.
J. Burja +7 more
core +2 more sources
Influence of Slag Composition and Temperature on Slag Foaming.
The slag foaming behavior caused by the reaction between FeO containing slag and hot metal was investigated for the CaO-SiO2-Al2O3-P2O5-TiO2-MnO-MgO-CaF2 system. The peak of slag foaming height was observed when (CaO)/(SiO2) was around 1.2 and the peak value of (CaO)/(SiO2) became slightly large with the increase in temperature and the CaF2 mixing ...
Kitamura, Shin-ya, Okohira, Kazuo
openaire +2 more sources
On the dissolution behavior of sulfur in ternary silicate slags
Sulfur dissolution behavior, in terms of sulfide capacity (C S), in ternary silicate slags (molten oxide slags composed of MO - NO - SiO 2, where M and N are Ca, Mn, Fe, and Mg), is discussed based on available experimental data.
���������
core +2 more sources
Utilization of Slags from Foundry Process [PDF]
The melting of steel or cast iron is one step of the foundry process. The foundry industry uses different types of furnaces, and metallurgical slags are products of the pyrometallurgical processes defecting in these furnaces.
Jozef Petrík +11 more
core +2 more sources
The steel industry accounts for about 7%‐9% of global CO2 emissions. While H2‐based direct reduction is a long‐term route, near‐term solutions are needed for existing plants. Internal carbon cycles reuse steelworks off‐gases and by‐products, enabling circular carbon use and supporting CCU integration.
Florian Haakmann +4 more
wiley +1 more source
Slag Splashing: simulation and analysis of the slags conditions
The successful application of the repair and prevention of LD converters refractories technique called Slag Splashing requires a close control of the slag physicochemical properties (basicity, viscosity and surface tension), as well as suitable selection of operational parameters and geometric configurations.
Inamara Amanda Souza Santos +5 more
openaire +2 more sources
According to the experimental results of hot metal dephosphorization by CaO-based slags at a commercial-scale hot metal pretreatment station, activity of P2O5 in the CaO-based slags has been determined using the calculated comprehensive mass action ...
Duan, Dong-Ping +4 more
core +1 more source

