Results 121 to 130 of about 13,293,543 (349)
Microstructural modelling of creep crack growth from a blunted crack [PDF]
The effect of crack tip blunting on the initial stages of creep crack growth is investigated by means of a planar microstructural model in which grains are represented discretely. The actual linking-up process of discrete microcracks with the macroscopic
Giessen, E. van der +4 more
core
Abruptly changing from aerobic to anaerobic conditions (sudden anaerobization) induced growth inhibition and a significant increase in intracellular labile ferrous iron in the aerotolerant anaerobe Amphibacillus xylanus. We found that free flavins mediate efficient electron transfer from NADH to ferric iron under anaerobic conditions, suggesting that ...
Shinya Kimata +13 more
wiley +1 more source
Dynamic Terminal Sliding Mode Control for an Aerospace Launch Vehicle [PDF]
Tracking guidance commands for a time-varying aerospace launch vehicle during the atmospheric flight is considered in this paper. Hence, the dynamic terminal sliding mode control law is constructed for this purpose and dynamic sliding mode control is ...
Ali Reza Alikhani +1 more
doaj
TisIBP8, a fungal‐derived hyperactive ice‐binding protein, helps Caenorhabditis elegans survive dehydration. It localizes near cell membranes, reduces cell damage, and helps maintain membrane structure during drying. These results suggest that ice‐binding proteins can protect cells from dehydration stress as well as freezing stress.
Daiki Shimose +9 more
wiley +1 more source
Sliding wear of titanium [PDF]
Titanium pins were slid against flat surfaces of alumina disks under dry condition and a normal load of 50 N at sliding speeds varying from 0.1 to 4 ms-1.
Biswas, SK, Kailas, SV
core +1 more source
Prosopis juliflora (PJ) fibre-reinforced polymer composites are fabricated with fly ash and SiC as fillers with different weight percentages. Jute layers are also sandwiched for added strength in the structure.
Suresh Thirupathi +4 more
doaj +1 more source
Experimental Study on Dry Friction Behavior of AlumiNm Alloy Casing
In order to study the frictional and wear behavior of alumiNm alloy casing in gas drilling technology, under dry friction conditions, taking 40CrNmo steel as the pin and 7075 alumiNm alloy as the disc, by means of pin-disc wear test system, the effects ...
Xing Xuesong, Zhang Huizeng, Li Juan
doaj
The friction and wear behaviors of biodegradable Mg-6Gd-0.5Zn-0.4Zr (wt%, GZ60K) alloy were evaluated under simulated body fluid (SBF) condition using ball-on-disk configuration and compared with those under dry sliding condition.
Jianwei Dai +5 more
doaj +1 more source
Hyperosmotic stress triggers the relocation of the CFIm complex from the nucleus to the cytoplasm. This shift creates a nuclear ‘stoichiometric bottleneck’, limiting CFIm availability for mRNA processing. Consequently, specific mRNAs like NUDT21 and DICER1 undergo targeted 3′UTR shortening, demonstrating how spatial protein dynamics drive rapid ...
Hitomi Soumiya +2 more
wiley +1 more source
Sliding Mode Flow Rate Observer Design [PDF]
Dynamic flow rate information is needed in a lot of applications; however it is normally not measurable. Calculation of the flow rate from fluid pressure dynamic equations usually results in poor estimates due to the very noisy pressure measurements and ...
Song Liu, Bin Yao
core

