Results 161 to 170 of about 27,052 (317)

Multi-Target Radar Speed Meter Failure Mechanism Research. [PDF]

Sensors (Basel)
Luo L, Jiang X, Shao J, Chen C, Zhao C, Zhang X, Shen X.   +6 more
europepmc   +1 more source

Anode‐Free All‐Solid‐State Batteries: Understanding Limitations and Charting a Path to Enhanced Performance

Small, EarlyView.
This review examines four factors that drive interfacial instability in sulfide‐based anode‐free all‐solid‐state batteries and thoroughly reviews corresponding performance‐enhancing strategies. The strategies are organized as follows: (1) interlayer engineering, (2) pressure‐regulating buffer layers, (3) other methods, including sacrificial cathodes ...
Sion Kim, Jaechan Lee, Jihyun Jang
wiley   +1 more source

Low-Temperature Sintering Mechanism and Bonding Performance of Submicron Triangular Silver Paste for Advanced Electronic Packaging. [PDF]

Materials (Basel)
Lin P, Tong Z, Xu S, Wang Y, Wang S, Tian Y.   +5 more
europepmc   +1 more source

Recycling End‐of‐Life Solid Oxide Cell Interconnect Assemblies into Commercial‐Grade AISI 304 Stainless Steels

steel research international, EarlyView.
This study validates a recycling pathway for converting interconnect assemblies from end‐of‐life SOC stacks into commercial‐grade AISI 304 steels. Using scrap‐based steelmaking operations, austenitic cast steels with <4.0% δ‐ferrite are successfully produced.
Jeraldine Lastam, Shine‐Od Mongoljiibuu, Alexander Specht, Daniel Grüner, Dmitry Sergeev, Urs A. Peuker, Michael Müller, Ruth Schwaiger   +7 more
wiley   +1 more source

Effects of Al Element on the Microstructure and Properties of Sn-9Zn Solder Alloy. [PDF]

Materials (Basel)
Yang J, You Y, Jiang G, Li C.
europepmc   +1 more source

Analyses of the Deformability and Chemistry of Non‐Metallic Inclusions in QT Steels With Increased Recycling‐Induced Tramp Element Content

steel research international, EarlyView.
This work uses high‐temperature dilatometry to examine how the tramp elements Cu, Ni, and Sn affect the deformability of non‐metallic inclusions and matrix in quench‐and‐temper steel. Mg‐bearing inclusions deform less than Mg‐free ones. Copper lowers formability. Nickel increases deformability.
Julian Cejka, Isabell Gruber, Gerald Klösch, Susanne Katharina Michelic   +3 more
wiley   +1 more source

A method for recognizing positive and negative electrodes of buzzer circuit board based on machine vision. [PDF]

PLoS One
Liu X, Wang C, Huang X, Sun C, Zhu R, Hu C, Ding Q.   +6 more
europepmc   +1 more source

Design of automatic vision-based inspection system for solder joint segmentation

, 2009
Purpose: Computer vision has been widely used in the inspection of electronic components. This paper proposes a computer vision system for the automatic detection, localisation, and segmentation of solder joints on Printed Circuit Boards (PCBs) under ...
Yarlagadda, Prasad K., Mar, Nang Seng Siri, Fookes, Clinton   +2 more
core  

Tailoring Model‐Based Systems Engineering for Sub‐100 g PlanarSats: A Power‐First View Stack

Systems Engineering, EarlyView.
ABSTRACT This paper addresses how to apply model‐based systems engineering (MBSE) to ultrasmall planar satellites under severe power and resource constraints. PlanarSats are sub‐100‐gram spacecraft built as single printed‐circuit boards where the same surface must host both electronics and solar cells, so power generation, geometry, and component ...
Mehmet Şevket Uludaǧ, Alim Rüstem Aslan   +1 more
wiley   +1 more source

Progress and Challenges in Joining for Precision Endoscope Fabrication. [PDF]

Sensors (Basel)
Xu P, Zheng X, Li L, Wang Z.
europepmc   +1 more source