Results 51 to 60 of about 39,958 (213)
Novel ZVS S-TCM Modulation of Three-Phase AC/DC Converters
For three-phase AC-DC power conversion, the widely-used continuous current mode (CCM) modulation scheme results in relatively high semiconductor losses from hard-switching each device during half of the mains cycle.
Michael Haider +7 more
doaj +1 more source
Modulated Model-Free Predictive Control With Minimum Switching Losses for PMSM Drive System
A modulated model-free predictive control with minimum switching losses (MSL-MMFPC) is proposed to improve the steady-state performance and reduce the switching losses for a permanent magnet synchronous motor (PMSM) drive system.
Yuchen Wang +4 more
doaj +1 more source
Voltage sags and swells are the major problems of the power distribution system that arise due to uneven distribution of the single-phase and nonlinear loads.
Naveed Ashraf +5 more
doaj +1 more source
Switching losses in three-phase voltage source inverters [PDF]
The efficiency of three-phase voltage source inverters depends mainly on power losses that occur in semi-conductor elements. Total losses in these elements are a sum of conduction losses and switching losses.
Mazgaj, Witold +2 more
core
In future more electric aircraft (MEA) applications increased requirements of power levels stress the importance of low losses in converters and switching elements.
L. Austrin +5 more
core +1 more source
A New Fully Soft‐Switching High Step‐Up Interleaved Converter for Optimal Efficiency
A novel fully soft‐switching interleaved high step‐up converter is introduced in this paper. The suggested converter achieves high voltage gain using coupled inductors (CI) and a voltage multiplier cell (VMC).
Arsalan Erfani +2 more
doaj +1 more source
Reduction of switching losses and passive components rating in series-connected current source inverters [PDF]
The current source inverter (CSI) is widely used in medium voltage drives due to its simple configuration, reliable short-circuit protection, and low dv/dt issue.
Xia, Xiaoyi
core
Power Semiconductor Losses Simulation Capabilities in Matlab/Simulink
The paper describes methods of simulation conduction and switching losses of power semiconductors in MATLAB/Simulink. The comparison of simulation results for Infineon’s semiconductor with PLECS Standalone simulation is presented.
Gordan Daniel, Pástor Marek
doaj +1 more source
Effects of Hearing Loss on Maintaining and Switching Attention
The ability to intentionally control attention based on task goals and stimulus properties is critical to communication in many environments. However, when a person has a damaged auditory system, such as with hearing loss, perceptual organization may also be impaired, making it more difficult to direct attention to different auditory objects in the ...
Adrian Kc, Lee +2 more
openaire +2 more sources
Efforts to minimise the size and material usage of power converters are reflected in efforts to increase the switching frequency. The problem is that semiconductor switching losses are proportional to the switching frequency, so it is necessary to find ...
Pástor Marek +2 more
doaj +1 more source

