Results 81 to 90 of about 333,530 (288)
Optimum topological configurations of sensor networks
Computing in Construction, 2019 mportant task in the dynamic assessment of the mechanical systems and its role is central in structural health monitoring. All sensors have to be placed on the structure so that all sought system features be obtained from the experimental tests. Sensors network design is rather diffused in laboratory applications, but there are scarce investigations on
Greco R., Marano G. C.
openaire +3 more sources
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Advanced Engineering Materials, EarlyView.Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
Communications EngineeringThe distribution of current/voltage can be further regulated by optimising the electrical connection topology, considering a particular battery thermal management systems.
Haosong He +3 more
doaj +1 more source
Frontiers in Energy ResearchOptimizing the configuration of acquisition terminals can maximize the observability and state estimation accuracy of the distribution grid achieving comprehensive perception of the distribution grid.
Yi Xuan +10 more
doaj +1 more source
The Journal of Engineering, 2019 This paper presents a modular multilevel converter (MMC) configuration that utilises energy exchange between sub-modules (SMs) of upper and lower arms, for energy rebalancing.
Mohamed S. Diab +4 more
doaj +1 more source
An automated topological analysis of Multiple Routing Configurations
2015 36th IEEE Sarnoff Symposium, 2015 Topological changes in IP networks may significantly influence the performance of networking algorithms, which therefore should be carefully evaluated using a large topology pool with diverse characteristics. In this paper, we present an automated topology generation and analysis tool to perform an elaborate topological dependency analysis of a Multi ...
Selcuk Cevher +2 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
A first family of stable configurations to model magnetic fields in stellar radiation zones
, 2010 We conduct 3D magneto-hydrodynamic (MHD) simulations in order to test the stability of the magnetic equilibrium configuration described by Duez & Mathis (2010).
Braithwaite, J., Duez, V., Mathis, S.
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source