Results 21 to 30 of about 4,418 (232)
On the Analysis of the Contact Conditions in Temporomandibular Joint Prostheses [PDF]
Temporomandibular joint replacement (TMJR) is a complex surgical procedure in which the artificial joints available must assure the anatomical reconstruction and guarantee a good range of the natural temporomandibular joint (TMJ) movements. With this aim,
Centeno Báez, Gabriel +3 more
core +2 more sources
Corrosion, tribology and tribocorrosion research in biomedical implants : progressive trend in the published literature [PDF]
There has been significant progress in implant research during last the 10 years (2005–2015). The increase in the elderly population coupled with a lack of proper physical activity is a potential cause for the sudden increment in implant usage.
Bijukumar, D. +6 more
core +1 more source
The safety of mooring systems and accessories is one of the most critical issues in the structural integrity of floating oil/gas and renewable offshore structures.
Sabri Alkan
doaj +1 more source
Mechanical and electrochemical deterioration mechanisms in the tribocorrosion of Al alloys in NaCl and in NaNO3 solutions [PDF]
Tribocorrosion of Al-Si-Cu-Mg alloys was investigated in 0.05 M NaCl and 0.1 M NaNO3 solutions under severe sliding and controlled electrochemical conditions.
Mischler, S. +3 more
core +1 more source
Effect of Cationic/Anionic Diffusion Dominated Passive Film Growth on Tribocorrosion
Tribocorrosion behaviours of nickel (Ni) and niobium (Nb) in sodium sulfate (Na2SO4) solution under potentiodynamic and potentiostatic conditions were studied.
Renpeng Zhang +4 more
doaj +1 more source
Wear and corrosion interactions on titanium in oral environment : literature review [PDF]
The oral cavity is a complex environment where corrosive substances from dietary, human saliva, and oral biofilms may accumulate in retentive areas of dental implant systems and prostheses promoting corrosion at their surfaces.
A Bardow +122 more
core +1 more source
The tribocorrosion behavior of Ti6Al4V alloy was investigated in a Phosphate Buffered Saline (PBS) solution by a reciprocating wear, using alumina ball as the counterface material, at different normal forces and sliding velocities.
Taíse M. Manhabosco +2 more
doaj +1 more source
The evolution of microstructures and the mechanical properties of the fabricated compacts were analyzed following pulsed electric current sintering (PECS) of ceramics reinforced titanium samples. The Vickers microhardness values of the fabricated samples
Olusoji Oluremi Ayodele +2 more
doaj +1 more source
Tribocorrosion behaviour of ZrOxNy thin films for decorative applications [PDF]
The aim of this work is the investigation of the tribocorrosion behaviour of single layered zirconium oxynitride, ZrOxNy, thin films in 11 reciprocating sliding and immersed in an artificial sweat solution at room temperature.
Alves, E. +9 more
core +1 more source
Sintering of nanocrystalline materials: Sintering parameters
Nanostructured materials (NsM) are typical materials with structural length scales of one, two, or three dimensions in the range of 1–100 nm. In the development of NsM, the microstructure of a material, which is an integral factor in determining the ...
Bukola Joseph Babalola +2 more
doaj +1 more source

