Results 61 to 70 of about 14,688 (266)

Microstructure Evolution of a VMnFeCoNi High‐Entropy Alloy After Synthesis, Swaging, and Annealing

open access: yesAdvanced Engineering Materials, EarlyView.
The synthesis and processing (rotary swaging and annealing) of the novel VMnFeCoNi alloy is investigated, alongside the estimation of the grain size effect on hardness. Analysis of a wide grain size range of recrystallized microstructures (12–210 µm) reveals a low annealing twin density.
Aditya Srinivasan Tirunilai   +6 more
wiley   +1 more source

Reducing the tension–compression yield asymmetry of extruded Mg–Zn–Ca alloy via equal channel angular pressing

open access: yesJournal of Magnesium and Alloys, 2015
The influence of equal channel angular pressing on the tension–compression yield asymmetry of extruded Mg–5.3 Zn–0.6 Ca (weight percent) alloy has been investigated.
L.B. Tong   +6 more
doaj   +1 more source

Effect of Stacking Fault Energy on Microstructure and Texture Evolution during the Rolling of Non-Equiatomic CrMnFeCoNi High-Entropy Alloys

open access: yesCrystals, 2020
The evolution of microstructure and texture in three non-equiatomic CrMnFeCoNi high-entropy alloys (HEAs) with varying stacking fault energy (SFE) has been studied in up to 90% rolling reductions at both room and cryogenic temperature.
G. Dan Sathiaraj   +3 more
doaj   +1 more source

Slip Localization Intensification Mediated by Grain Boundary Sliding in a Polycrystalline Nickel‐Based Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
The temperature dependence of fatigue behavior in nickel‐based superalloys is investigated through high‐resolution measurements of plastic localization. While increasing temperature reduces localization and enhances fatigue performance in René 88DT, Inconel 718 exhibits a sharp degradation at intermediate temperature due to intensified slip ...
M. Calvat   +5 more
wiley   +1 more source

Effect of twinning crystal on hydrogen embrittlement behavior of high-manganese steel produced by wire and arc additive manufacturing

open access: yesHanjie xuebao
To investigate the effect of twinning crystal fraction on the hydrogen embrittlement behavior of high-manganese steel fabricated by wire and arc additive manufacturing (WAAM), tensile pre-straining was employed to prepare microstructures with different ...
Shengbin PEI   +6 more
doaj   +1 more source

Impact of Deformation Twinning on the Mechanical Properties of B.C.C.-Lattice-Based Alloys

open access: yesУспехи физики металлов, 2017
Deformation twinning exerts a great influence on the low-temperature plasticity of b.c.c. metals. The article reviews publications relating to this problem.
Yu. V. Milman, I. V. Goncharova
doaj   +1 more source

Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A

open access: yesAdvanced Engineering Materials, EarlyView.
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han   +5 more
wiley   +1 more source

Polimorfisme Protein Serum Darah Induk Sapi Beranak Kembar dan Tunggal pada Sapi Peranakan Ongole dan Keturunan Simental (BLOOD SERUM PROTEIN POLYMORPHISM OF THE COW DELIVERED TWIN OR SINGLE CALVES IN ONGOLE GRADE AND SIMENTAL CROSSBRED)

open access: yesJurnal Veteriner, 2017
The twinning cow is presumable have difference in blood protein typology with the single cow. Thestudy investigated blood protein polymorphism in twinning and single of ongole grade and Simmentalcrossbred cows.
Tri Yuwono   +3 more
doaj  

High‐Temperature Nanoindentation of Metals: Assessing Thermal Drift, Frame Compliance, and Chemical Composition Effects on the Reported Mechanical Properties

open access: yesAdvanced Engineering Materials, EarlyView.
Do not let thermal drift and instrument artifacts deceive high‐temperature nanoindentation results. We compare classical Oliver–Pharr and automatic image recognition analyses across steels and a Ni alloy to quantify these effects. Accounting for artifacts reveals systematic softening with temperature, while Cr and Ni additions boost resistance ...
Velislava Yonkova   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy