Results 21 to 30 of about 678,734 (304)
A finite control set model predictive control method for matrix converter with zero common-mode voltage [PDF]
In this paper a finite control set model predictive control method is presented that eliminates the common-mode voltage at the output of a matrix converter.
Dan, Hanbing +6 more
core +1 more source
The improvement of the line Load-ability (LL) for voltage stability establishes the main criterion for distribution networks. The Distributed Generation (DG) resources play an important role in the supply of active and reactive power loads, bus voltage ...
Mohammad Kazeminejad, Mahdi Banejad
doaj +1 more source
Comparison of V2IC control with voltage mode and current mode controls for high frequency (MHz) and very fast response applications [PDF]
High switching frequencies (several MHz) allow the integration of low power DC/DC converters. Although, in theory, a high switching frequency would make possible to implement a conventional Voltage Mode control (VMC) or Peak Current Mode control (PCMC ...
Alou Cervera, Pedro +4 more
core +1 more source
This paper introduces a novel control strategy that merges integral sliding mode control with fuzzy adaptive PI control. This hybrid approach maximizes the benefits of both techniques to ensure voltage stability in DC microgrid.
Xinyu Zhang +6 more
doaj +1 more source
Chaos control of voltage mode controlled buck-boost converter
Due to the limitation to the development level of modern science and technology, DC-DC (where DC stands for direct current) converters operating in chaotic state cannot be used to achieve some desired goals yet and the chaotic phenomena occurring in DC-DC converters are almost restrained. For DC-DC converter operating in continuous conduction mode (CCM)
null Zheng Lian-Qing, null Peng Yi
openaire +1 more source
Distributed secondary control of microgrids with unknown disturbances and non-linear dynamics
In this paper, the voltage and frequency regulation of microgrid with unknown disturbances and non-linear dynamics was studied. The disturbance observer was designed and the sliding mode control (SMC) method was used to realize the secondary regulation ...
Shunwei Hu +9 more
doaj +1 more source
For two-stage grid-connected photovoltaic (PV) system, if the low voltage ride through (LVRT) faults occur in the grid side, because the grid voltage falls to a relative low value and the output current is limited, then the output power of inverter ...
Yangyang Wu +10 more
doaj +1 more source
Control of Transient Power during Unintentional Islanding of Microgrids [PDF]
In inverter-based microgrids, the paralleled inverters need to work in grid-connected mode and stand-alone mode and to transfer seamlessly between the two modes. In grid-connected mode, the inverters control the amount of power injected into the grid. In
Abusara, Mohammad +2 more
core +1 more source
In a photovoltaic DC microgrid, the intermittent power supply of the distributed generation and the fluctuation of the load power will cause the instability of the bus voltage.
Siyuan Liu +7 more
doaj +1 more source
A three-switch high-voltage converter [PDF]
A novel single active switch two-diodes high-voltage converter is presented. This converter can operate into a capacitor-diode voltage multiplier, which offers simpler structure and control, higher efficiency, reduced electromagnetic interference (EMI ...
Pietkiewicz, Andzrej +2 more
core +1 more source

