Results 101 to 110 of about 1,793,673 (287)

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

A novel inductive electromagnetic energy harvester for condition monitoring sensors [PDF]

open access: yes, 2010
As the operation of electrical power networks becomes increasingly sophisticated, the role of condition monitoring is expanding. The burden of implementing additional condition monitoring will be eased if self-powered, fully autonomous sensors can be ...
Fraser, Leigh   +2 more
core  

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

open access: yesAdvanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek   +5 more
wiley   +1 more source

EBSD Study of Creep‐Induced Lattice Misorientation in MgO‐Particle‐Reinforced Austenitic Steel Composites

open access: yesAdvanced Engineering Materials, EarlyView.
Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller   +6 more
wiley   +1 more source

Revisiting the Influence of Lending Rate to Indonesia’s Credit Market

open access: yesThe International Journal of Financial Systems
This paper investigates the responsiveness of credit volumes to changes in lending rates in Indonesia and reexamines the strength of the monetary transmission mechanism through the credit channel.
Afif Narawangsa Luviyanto   +2 more
doaj   +1 more source

On the Throughput of Channels that Wear Out

open access: yes, 2018
This work investigates the fundamental limits of communication over a noisy discrete memoryless channel that wears out, in the sense of signal-dependent catastrophic failure.
Tan, Vincent Y. F.   +2 more
core   +1 more source

Home - About - Disclaimer - Privacy