Results 81 to 90 of about 44,596 (308)

Microstructural Evolution and Vacancy Defect Formation in Mn–Mo–Ni RPV Steel Under Low Cycle Fatigue: Insights From EBSD and PALS

open access: yesAdvanced Engineering Materials, EarlyView.
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar   +2 more
wiley   +1 more source

Three-Direction Type of Diffuser-Shaped Vortex Generator Development for the Wind Solar Tower

open access: yesEnergies
This study explored the use of diffuser shapes to enhance the performance of a solar updraft tower. A diffuser-shaped vortex generator, a simple device requiring no structural modifications to the tower, was installed at the chimney outlet. The generator
Anan Sudsanguan   +2 more
doaj   +1 more source

A study on vortex flow control on inlet distortion in the re-engined 727-100 center inlet duct using computational fluid dynamics [PDF]

open access: yes
Computational fluid dynamics was used to investigate the management of inlet distortion by the introduction of discrete vorticity sources at selected locations in the inlet for the purpose of controlling secondary flow.
Anderson, Bernhard H.   +3 more
core   +1 more source

Detection of hydraulic phenomena in francis turbines with different sensors [PDF]

open access: yes, 2019
Nowadays, hydropower is demanded to provide flexibility and fast response into the electrical grid in order to compensate the non-constant electricity generation of other renewable sources.
Egusquiza Estévez, Eduard   +4 more
core   +2 more sources

Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma

open access: yesAdvanced Engineering Materials, EarlyView.
The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie   +4 more
wiley   +1 more source

Application of Computational Fluid Dynamics to the Study of Vortex Flow Control for the Management of Inlet Distortion [PDF]

open access: yes
The present study demonstrates that the Reduced Navier-Stokes code RNS3D can be used very effectively to develop a vortex generator installation for the purpose of minimizing the engine face circumferential distortion by controlling the development of ...
Anderson, Bernhard H., Gibb, James
core   +1 more source

Effect of Oxygen Content on Surface and Subsurface Integrity During Turning of Ti–6Al–4V

open access: yesAdvanced Engineering Materials, EarlyView.
This study examines how oxygen content in the ambient atmosphere affects the surface and subsurface properties of Ti–6Al–4V during turning. Results show that oxygen does not influence surface roughness. However, machining in an extremely high vacuum‐adequate atmosphere increases surface hardness by up to 7.8% and induces compressive residual stresses ...
Benjamin Bergmann   +3 more
wiley   +1 more source

A universal time scale for vortex ring formation [PDF]

open access: yes, 1998
The formation of vortex rings generated through impulsively started jets is studied experimentally. Utilizing a piston/cylinder arrangement in a water tank, the velocity and vorticity fields of vortex rings are obtained using digital particle image ...
Gharib, Morteza   +2 more
core   +1 more source

Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere

open access: yesAdvanced Engineering Materials, EarlyView.
A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz   +4 more
wiley   +1 more source

Vortex-Induced Vibration Suppression of a Circular Cylinder with Vortex Generators

open access: yesShock and Vibration, 2016
The vortex-induced vibration is one of the most important factors to make the engineering failure in wind engineering. This paper focuses on the suppression method of vortex-induced vibration that occurs on a circular cylinder fitted with vortex ...
Shi-bo Tao   +4 more
doaj   +1 more source

Home - About - Disclaimer - Privacy