Results 221 to 230 of about 5,559,545 (283)

Anode-Layer Ion Source-Assisted Deposition and Bias Voltage Tuning of CrWNbTaMoVSiN High-Entropy Nanostructured Coatings. [PDF]

Nanomaterials (Basel)
Ling Y, Liu S, Tian C, Zou C.
europepmc   +1 more source

Limiting PcV and Tribological Performance of Mechanical Seals with Hard-Hard and Soft-Hard Tribopairs Under Water Lubrication. [PDF]

Materials (Basel)
Ren X, Song H, Li H, Zhou Y, Li M, Yang S, Liu C, Lu Y, Li X, Jiang N, Nishimura K.   +10 more
europepmc   +1 more source

Comparative Study of Microstructure, Phase Composition, Hardness, and Tribological Behavior of Low-Carbon Steel After Electrolytic-Plasma and Laser Surface Hardening. [PDF]

Materials (Basel)
Sulyubayeva L, Buitkenov D, Maulit A, Alibekova B, Bolatov S.   +4 more
europepmc   +1 more source

Rare Earth-Enhanced Laser Cladding Metal-Based Coatings: A Review. [PDF]

Materials (Basel)
Xiao J, Tao D, Zheng Y, Yang J, Huang L, Liu W, Fu H, Li Y, Wang K.   +8 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Wear Rates of Resin Composites

Operative Dentistry, 2013
SUMMARY A laboratory study was conducted to examine the wear of resin composite materials using a generalized wear simulation model. Ten specimens each of five resin composites (Esthet•X [EX], Filtek Supreme Plus [SP], Filtek Z250 [Z2], Tetric EvoCeram [EC], and Z100 Restorative [Z1]) were subjected to wear challenges of 100,000, 400,000,
W W, Barkmeier, R I, Erickson, M A, Latta, T M, Wilwerding   +3 more
openaire   +2 more sources

Effect of Tire Wear on Wear Rate

Tire Science and Technology, 1975
Abstract A question arises as to whether the wear rate of tires is constant under constant conditions and whether the tread life of tires may therefore be projected by linear extrapolation from low mileage tests. A second question arises as to whether commercially produced tires are uniform enough to serve as monitors of environmental change. A
F. C. Brenner, S. R. Scheiner, A. Kondo
openaire   +1 more source

Prediction of Tire Tread Wear Rate and Tread Wear Rate Differences

Tire Science and Technology, 1979
Abstract A method is presented for the analysis of tread wear test data, having the principal aim of predicting the ultimate tread life from results of a test suspended near the halfway mark. This method uses standard regression analysis of a suitable model followed by Bayesian inference to produce subjective probability distributions of ...
E. A. Dudley, R. F. Bauer, P. M. Reilly
openaire   +1 more source

Wear-rate transitions and their relationship to wear mechanisms

Acta Metallurgica, 1987
Abstract This paper is concerned with ways of classifying wear and presenting the information on a wear map. The unlubricated sliding wear of steel is classified into seven elementary mechanisms of material removal. The two principal modes of wear, namely mild and severe wear, provide an alternative but related classification.
S.C. Lim, M.F. Ashby, J.H. Brunton
openaire   +1 more source

Radiation sterilization and the wear rate of polyethylene

Journal of Orthopaedic Research, 1984
AbstractThe resistance to sliding wear was measured in bovine serum for two polyethylenes with molecular weights of about 105 and 106 that had been irradiated in air and nitrogen with γ‐ray dosages up to 20 Mrad. Molecular weight measurements were performed after irradiation as well.
R M, Rose, E V, Goldfarb, E, Ellis, A N, Crugnola   +3 more
openaire   +2 more sources

Tire Wear Rates

Tire Science and Technology, 1980
Abstract During the early stages of tire wear, the wear rate determined from groove depth measurements may reflect a dimensional change not associated with rubber loss, that is superimposed on the tread loss. The combined effect can be fit with an exponential decay curve relating groove depth to miles run.
openaire   +1 more source