Results 11 to 20 of about 2,434,290 (279)
Sliding wear of nitrided steels [PDF]
, 1993 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The unlubricated sliding wear behaviour of gas nitrided, plasma nitrided, and ferritic nitrocarburized BS970,905M39 (EN41B) steels was investigated ...
Kato, Hirotaka
core +7 more sources
Wear maps for TiC composite based coatings deposited on 303 stainless steel [PDF]
, 2014 Dry sliding wear (pin-on-disc) tests were carried out under ambient conditions at room temperature for TiC coated and uncoated 303 stainless steel, using alumina as a counterface.
Stack, M.M., Rasool, G.
core +4 more sources
Influence of temperature and crystal orientation on tool wear during single point diamond turning of silicon [PDF]
, 2012 Owing to the capricious wear of cutting tools, ultra precision manufacturing of silicon through single point diamond turning (SPDT) operation becomes a challenging task.
Reuben, Robert L +3 more
core +4 more sources
Materials Research Express, 2020 The friction and wear behavior of an Mg-10Gd-1.4Y-0.4Zr alloy were investigated in detail within a temperature range of 20 °C–200 °C in order to clarify temperature-induced mild-severe (M-S) wear transition mechanism and verify if contact surface dynamic
Yuanbo Wang +3 more
doaj +1 more source
High Temperature Tribological Behavior of Borocarburized Layer on Q235 Steel
Medžiagotyra, 2021 A borocarburized layer was successfully fabricated on the surface of Q235 low-carbon steel via double glow treatment to improve the wear resistance at elevated temperature.
Zhengang YANG +5 more
doaj +1 more source
Wear Mode Map of Current Collecting Materials
Tribology Online, 2019 Conventionally, several reports on quantification of wear of current collecting materials have been published. The objectives of these reports were to predict the wear of current collecting materials in field.
Chikara Yamashita, Koshi Adachi
doaj +1 more source
[RETRACTED ARTICLE]: Load Dependent Wear Analysis of Manganese Steels - Influence of Al Content [PDF]
Materials Research, 2017 In this paper influence of load on change in weight loss (mg), hardness and wear transition of 0.12 wt.% Al-Mn-steel (Steel A), 0.35 wt.% Al-Mn-steel (Steel B) and Mn-steel (Steel C) has been examined.
Rahul Sinha, Alok Kumar Mukhopadhyay
doaj +1 more source
Future Developments of a Deformation - Wear Transition Map of DLC Coating
Tribology Online, 2012 The deformation-wear transition map of hydrogen-free amorphous carbon coating (commonly known as Diamond-Like Carbon (DLC)) is intended to graphically distinguish between the plastic deformation and impact wear of DLC coating, as well as, to predict its ...
Mohd Fadzli Bin Abdollah +6 more
doaj +1 more source
Abrasive wear with particular reference to digger teeth [PDF]
, 1987 This thesis was submitted for the degree of Doctor of Philosophy and was awarded by Brunel University.Abrasive wear occurs when a contact associated with stress between a metal surface and a herd particle (frequently of mineral origin) leads to ...
Mashloosh, KM
core +6 more sources
Adhesive wear mechanisms uncovered by atomistic simulations
Friction, 2018 In this review, we discuss our recent advances in modeling adhesive wear mechanisms using coarse-grained atomistic simulations. In particular, we present how a model pair potential reveals the transition from ductile shearing of an asperity to the ...
Jean-François Molinari +4 more
doaj +1 more source