Results 41 to 50 of about 114,227,017 (255)
Conceptual Design and Preliminary Verification of Distributed Wireless System of Weigh-in-Motion
In this paper, the concept of a distributed wireless system of weigh-in-motion is proposed. A wireless sensor for weigh-in-motion (WIM) based on piezoelectric materials is designed.
Yun Wang +5 more
doaj +1 more source
Bridge Damage Detection Using Weigh-in-Motion Technology [PDF]
AbstractThis paper proposes a novel Level I damage-detection technique for short- to medium-span road bridges using weigh-in-motion (WIM) technology. The technique is based on the input provided by two WIM systems: (1) a pavement-based WIM station located in the same route as the bridge (which gives vehicle weight estimates without the influence of the
Cantero, Daniel, González, Arturo
openaire +4 more sources
Prototype Weigh-In-Motion Performance [PDF]
Oak Ridge National Laboratory (ORNL) has developed and patented methods to weigh slowly moving vehicles. We have used this technology to produce a portable weigh-in-motion system that is robust and accurate. This report documents the performance of the second-generation portable weigh-in-motion prototype (WIM Gen II).
Abercrombie, Robert K +4 more
openaire +2 more sources
Direct Measurement of Dynamics in Road Bridges Using a Bridge Weigh-In-Motion System
A method is presented of measuring a bridge’s characteristic allowance for dynamic interaction in the form of Assessment Dynamic Ratio. Using a Bridge Weigh-in-Motion system, measurements were taken at a bridge in Slovenia over 58 days.
Eugene J. OBrien +3 more
doaj +1 more source
Piezoelectric energy harvesting for powering a novel weigh-in-motion system
This paper describes the development and evaluation of a piezoelectric energy harvester (PEH) designed to power a novel system for weighing roadway vehicles in-motion.
Mohamadreza Khalili +2 more
doaj +1 more source
Direct Structural Response Monitoring Versus Weight-Based Damage Detection in Bridge Weigh-in-Motion
Bridge weigh-in-motion (BWIM) systems estimate axle and gross vehicle weights from measured bridge responses, typically strains but also displacements and rotations, via algorithms based on influence lines.
Kun Feng +2 more
doaj +1 more source
Research is strongest when conducted alongside patients, not just about them. Patient research organizations help integrate patient perspectives into research priorities, study design, and scientific meetings, leading to meaningful patient outcomes and development of relevant therapies.
Jenica H. Kakadia +9 more
wiley +1 more source
Strain Gauge Calibration for High Speed Weight-in-Motion Station
The development of systems for weighing vehicles in motion aims to introduce systems allowing automatic enforcement of regulations. HSWIM (high speed weight-in-motion) systems enable measurement of a mass of vehicles passing through a measurement station
Agnieszka Socha, Jacek Izydorczyk
doaj +1 more source
ABSTRACT Objective To evaluate the efficacy and safety of ofatumumab in patients with myelin oligodendrocyte glycoprotein antibody–associated disease (MOGAD), and compare it with rituximab. Methods We conducted a single–center, observational study including 22 MOGAD patients treated with ofatumumab and 21 treated with rituximab.
Yuxin Fan +5 more
wiley +1 more source
Development and Validation of Innovative Weighing in Motion Systems
The development of an efficient Weigh-In-Motion (WIM) system, with the aim of estimating the axle loads of railway vehicles in motion, is quite interesting from both an industrial and academic point of view. Such systems, with which the loading conditions of a wide population of running vehicles can be verified, are very important from a safety and ...
IGNESTI, MIRKO +4 more
openaire +3 more sources

