Results 221 to 230 of about 460,138 (357)

Effects of dodecyl amide, nano calcium carbonate, and dry resin on asphalt concrete cohesion and adhesion failures in moisture conditions. [PDF]

Sci Rep
Hamedi GH, Dehnad MH.
europepmc   +1 more source

An Injection‐Molded Modified Silicone Rubber for Cancer‐on‐Chip Applications

Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.
This study describes the characterization and application of an injection‐molded functionalized PDMS fluidic insert for the commercially available Micronit system. Modified PDMS can accommodate cell culture and is able to covalently bind proteins for long‐lasting coatings under flow‐conditions.
Ben J. Haspels, Frederikus Bakker, Lucas J. A. M. Beckers, Roland Kanaar, Koen C. Kriege, Susanne M. Valster, Roland C. M. Vulders, Maayke M. P. Kuijten   +7 more
wiley   +1 more source

CATALYZED HYDROLYSIS OF AMIDE AND PEPTIDE BONDS IN PROTEINS

, 1941
Jacinto Steinhardt
openalex   +1 more source

Towards the activity of twisted acyclic amides. [PDF]

RSC Adv
Tomasini M, Caporaso L, Szostak M, Poater A.   +3 more
europepmc   +1 more source

Protein hydrogen exchange in denaturant: quantitative analysis by a two-process model [PDF]

, 1994
Mayo, Stephen L., Morton, Andrew, Qian, Hong   +2 more
core   +1 more source

Xerogel Films with Ordered Silica Nanorods Enable Fine‐Tuned Polarized Structural Colors in Modular Nanocomposite Films

Advanced Materials Technologies, EarlyView.
Xerogel films with aligned silica nanorods are prepared through a facile stretching and air‐drying approach. By controlling the alignment of silica nanorods and configuring multilayer film stacks, vibrant and tunable polarized structural colors with hues including green and orange are achieved.
Wu Wei, Yu Yin, Qun Song, Dan Xu, Kai Zhang   +4 more
wiley   +1 more source

N- to C-Peptide Synthesis, Arguably the Future for Sustainable Production. [PDF]

J Pept Sci
Ghosh K, Lubell WD.
europepmc   +1 more source

Enhanced Performance 3‐D Printed PLA Parts through a Photo‐Initiator Mediated UV‐Curing

Advanced Materials Technologies, EarlyView.
This solvent‐free method enhances 3‐D printed PLA parts by incorporating photo‐initiators during fabrication, followed by up to 3 min UV treatment. This process improves PLA's mechanical properties, including a 64% increase in tensile strength, while addressing weak interlayer bonding and outdoor sensitivity.
Dylan Jubinville, Tizazu H. Mekonnen
wiley   +1 more source

so effective . . . so easy to make SODIUM amide [PDF]

, 1954

openalex   +1 more source

Diagnosis and risk stratification of PI-RADS v2.1 category 3-5 lesions using amide proton transfer imaging. [PDF]

World J Urol
Fang H, Hou W, Wang Q, Zhang X, Wang X, Zhang S, Li S, Li X, Yu Y.   +8 more
europepmc   +1 more source