Results 51 to 60 of about 23,915 (293)
Diffusion bonding of nickel-based powder metallurgy superalloy FGH98 with pure nickel interlayer
Journal of Materials Research and TechnologyFGH98 powder metallurgy superalloy were successfully bonded via diffusion bonding technique with pure Ni interlayer. It was indicated that adding the Ni interlayer can significantly reduce joint defects, promote elements diffusion, and improve the ...
Wei Guo +6 more
doaj +1 more source
Adhesively bonded single lap joint of composites
Ciencia y Poder Aéreo, 2013 A study of single lap joints of composite materials with and without attachments is presented. Failure of this type of joint is caused by the high peel stress in a perpendicular direction presented in the geometric singularity. It is shown that the joint
Peter Alvarado Prieto
doaj +1 more source
Advanced Engineering Materials, EarlyView.Mg–Zn composites with a thickness of 0.21 mm were fabricated using roll bonding of a kirigami‐patterned Mg alloy inlay within a Zn matrix. Thermal activation following this process led to the formation of tailored intermetallic structures, which provided the composite with enhanced flexural strength.
Yaroslav Frolov +4 more
wiley +1 more source
Influence of hydrothermal ageing on single lap bonded CFRP joints [PDF]
Fracture and Structural Integrity, 2018 Nowadays adhesive are widely used in structural applications, in particular for assembly composite materials. In fact, this technique allows to obtain a more uniform load in the joint, to realise a joint with an higher specific strength and to avoid ...
Costanzo Bellini +3 more
doaj +2 more sources
Fostering Innovation: Streamlining Magnetocaloric Materials Research by Digitalization
Advanced Engineering Materials, EarlyView.Magnetocaloric cooling (MCE) is an environmentally friendly refrigeration method with great potential. Optimizing MCE materials involves the preparation and screening of large quantities of samples, which in turn generates a large amount of data. A digitalization approach is presented that uses ontologies, knowledge graphs, and digital workflows to ...
Simon Bekemeier +17 more
wiley +1 more source
HeliyonWe aim to provide a study of material selection at the upper adherend subject for optimization of carbon fiber reinforced polymer (CFRP) adhesive-bonded joints with details on the stress distribution in the complex tri-material joint structure.
Shah Mohammad Azam Rishad +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.We develop a data‐driven method to derive the mathematical expressions of the Flory–Huggins interaction parameter χ for the swelling behavior of temperature–responsive hydrogels. Starting from initial assumptions of χ, our workflow combines Bayesian optimization, Flory–Rehner theory, and symbolic regression to generate candidate χ expressions.
Yawen Wang +2 more
wiley +1 more source
Evaluation of factors influencing adhesive bond strength
Research in Agricultural Engineering, 2006 In the last ten years periods the bonding technology noted a great boom not only in manufacturing industry but in repairing industry, too. The expansion of chemical industry is the cause of this boom.
M. Müller +3 more
doaj +1 more source
Effects of steps on the load bearing capacity of 3D-printed single lap joints
Journal of Materials Research and Technology, 2023 Damage in adhesively bonded joints typically initiates in the overlap area due to high level of bonding (peel) stress. Different approaches are being considered to decrease the peel stress and improve the overall strength of the joint.
Mohammad Reza Khosravani +2 more
doaj +1 more source
Finite element analysis of bonded crack retarders for integral aircraft structures [PDF]
, 2009 Trends in aircraft design and manufacture are towards the reduction of manufacturing cost and structural weight while maintaining high level of safety. These reductions can be achieved by using integral structures.
Boscolo, Marco
core