Results 181 to 190 of about 66,941,429 (215)
Some of the next articles are maybe not open access.
Design and Simulation of Pedal Simulator in Brake by Wire System
Applied Mechanics and Materials, 2014Wire of the brake pedal is not directly connected to the hydraulic environment in the braking By-wire system so the driver has no direct pedal feel. Then pedal simulator is an important part in the brake-by-wire system. A pedal force simulator was designed based on the traditional brake pedal curve of pedal force and pedal travel, AMESim and Matlab ...
Wen Bo Zhu, Fen Zhu Ji, Xiao Xu Zhou
openaire +1 more source
Modeling and Analysis of Brake by Wire System in Electric Vehicle
Applied Mechanics and Materials, 2012In order to improve performances of a virtual prototype, modeling and analysis are necessary before a system is produced and put into use. Firstly, structure and control schematics of electric vehicle with the steer by wire system and brake by wire system integrated are analyzed.
Lei Yan Yu, Wan Zhong Zhao, Jian Bo Yi
openaire +1 more source
Robust Wheel-Slip Control for Brake-by-wire Systems
SAE Technical Paper Series, 2005<div class="htmlview paragraph">Wheel-slip control systems are able to control the braking force more accurately and can be adapted to different vehicles more easily than conventional ABS systems. But, in order to achieve the superior braking performance, real-time information about the vehicle status variables such as wheel slip ratio, tire ...
Kunsoo Huh +4 more
openaire +1 more source
Brake-by-wire - The Braking System of the Future
ATZ worldwide, 2022Matthias Greiner +2 more
openaire +1 more source
SLIDING MODE SLIP-DECELERATION CONTROL FOR BRAKE-BY-WIRE CONTROL SYSTEMS
IFAC Proceedings Volumes, 2007Abstract In Anti-lock Braking Systems (ABS) two output variables are usually considered for regulation: wheel deceleration and wheel longitudinal slip. The wheel deceleration can be easily measured: however, it can be dynamically critical if the road-surface rapidly changes.
TANELLI, MARA +2 more
openaire +2 more sources
Software Implemented Detection and Recovery of Soft Errors in a Brake-by-Wire System
2008 Seventh European Dependable Computing Conference, 2008This paper presents an experimental study of the impact of soft errors in a prototype brake-by-wire system. To emulate the effects of soft errors, we injected single bit-flips into "live" data in the architected state of a MPC565 microcontroller. We first describe the results of an error injection campaign with a brake-by-wire controller in which ...
Daniel Skarin, Johan Karlsson
openaire +1 more source
Information on Brake-By-Wire (BBW) Brake Control Systems
2017<div class="section abstract"> <div class="htmlview paragraph">This SAE Aerospace Information Report (AIR) describes the design approaches used for current applications of aircraft Brake-by-Wire (BBW) control systems. The document also discusses the experience gained during service, and covers system, ergonomic, hardware, and development ...
openaire +2 more sources
Safety Critical Software Development for a Brake By-Wire System
SAE Technical Paper Series, 2006<div class="htmlview paragraph">Harmonizing software and hardware in addition to facilitating the analysis of intricate electronic systems from the functional perspective down to its low-level hardware and electronic implementation, transpires as an objective for safety analysis.
openaire +1 more source
Development of an intelligent perception system for an automotive brake-by-wire system
2009This thesis considers the problem of estimating clamp force in an electro-mechanical brake (EMB) for an automotive brake-by-wire (BBW) system. A clamp force sensor is typically used in EMB designs and the elimination of this component is strongly demanded due to implementation difficulties and cost issues.
openaire +1 more source
Fuzzy Logic Simulation for Brake-by-Wire Control System
2016Brake-by-wire technology describes the replacement of conventional components such as the pumps, brake fluids, and vacuum servos and master cylinders with electronic control unit, sensors and actuators. This paper shows designing of an electromagnetic braking system which is controlled by fuzzy logic technique, here electromagnetic braking system is ...
Pajarla Saiteja, S. Jeyanthi
openaire +1 more source