Determination of aluminium properties under bulk cold forming processes
, 2008 Consulta en la Biblioteca ETSI Industriales (7816)
openaire +2 more sources
Engineering ReportsThe increasing application of TA2 titanium profiles in marine and petrochemical industries has spurred in a growing demand for diverse forms, including U‐shaped, rectangular, and tubular thin‐walled profiles.
Mingze Yue +6 more
doaj +1 more source
The cooperation of Russian and German metal forming scientific schools to develop the new energy-efficient materials and technologies [PDF]
, 2013 The future scientific orientation of Katedra PDSS is in the area of materials forming and materials development with a focus on efficient processes regarding the use of energy and resources. Current research in the department PDSS is based on fundamental
Kawalla, R., Zinovyev, A. V.
core
The Structural Examination of Fe/(Cu/Nb)/MgB2 Multifilament Wires During Cold Forming Process
Journal of Advanced Applied SciencesIn this study, we have successfully produced a Fe-sheathed 6+1 multifilament wire using Cu/Nb/MgB2 monocore wires. The mono filament wire was prepared using Mg+2B powder mixture by powder-in-tube method without any intermediate heat treatment. The powder mixture of the amorphous nano boron (PVZ Nano Boron, purity of 98.5%, particle sizes < 250 nm ...
Doğan Avcı +3 more
openaire +1 more source
Teshugang, 2010 According to the present status of research and development of high strength non-quenched and tempered cold heading steel at home and abroad, the chemical composition, characteristics of process, structure and mechanical properties of 800 ~ 1200 MPa high
曹杰, 刘雅政, 阎军, 章静
doaj
Pemanfaatan Chitosan darimLimbah Udang (Penaneusmerquensis) sebagai Adsorben Ion Logam Krom.
, 2000 Di Indonesia udang diekspor dalam bentuk bekuannya melalui proses "cold storage". Akibat proses tersebut akan diperoleh hasil sainping berupa kepala, kulit, dan kaki yang merupakan iimbah.
Bangun , Disbon
core
A comparative study of strain- and stress-based failure prediction methods in single-point incremental forming of Al/Ti two-layer sheets considering different strain paths. [PDF]
Sci RepTayebi P, Meymand MM, Hashemi R.
europepmc +1 more source
Effect of Strain Rate on the Formability Prediction of Cold-Rolled DX56D+Z100-M-C-O Steel Sheets. [PDF]
Materials (Basel)Novák V +4 more
europepmc +1 more source
Microstructure Evolution and Plastic Deformation Mechanism of Cold Rolling Deformation of Micro/Nano Pure Electrolytic Nickel. [PDF]
Materials (Basel)Zhang H, Qiao J, Yang H, Xu Y, Xia T.
europepmc +1 more source