Results 31 to 40 of about 927,555 (356)
Numerical Simulation of Rock Plate Cutting with Three Sides Fixed and One Side Free
Advances in Materials Science and Engineering, 2018 In order to overcome conical pick wear in the traditional rock cutting method, a new cutting method was proposed on account of increasing free surface of the rock.
Zhenguo Lu +4 more
doaj +1 more source
A Cyclic Calibration Method of Milling Force Coefficients Considering Elastic Tool Deformation
Machines, 2023 In metal-cutting technology, milling plays an important role in the product development cycle. The accurate modeling and prediction of milling forces have always been research hotspots in this field.
Chang Yang, Rong Yu, Shanglei Jiang
doaj +1 more source
Simulation and Experimental Research on Cutting Force of Turning Titanium Alloy
MATEC Web of Conferences, 2015 This paper mainly establishes a two-dimensional model about the YG8 carbide tool turning TC4 titanium alloy on the basis of ABAQUS. The cutting force of the simulation model was verified by the turning experiment, and the relationships of cutting force ...
Zheng Qingchun +3 more
doaj +1 more source
Design and analysis of a piezoelectric film embedded smart cutting tool [PDF]
, 2012 This is the author's accepted manuscript. The final published article is available from the link below. Copyright @ 2012 Institution of Mechanical Engineers.The condition of a cutting tool is an important factor for manufacturing processes.
Cheng, K, Rakowski, R
core +1 more source
Modeling and simulation of a single abrasive grain micro-grinding force and temperature of bone
Journal of Biomechanical Science and Engineering, 2020 Grinding methods have been widely used in orthopedic surgery, which has high requirements for surface quality, grinding force and temperature control. It is necessary to explore the influence of micro-grinding parameters on the grinding force temperature
Heqiang TIAN +4 more
doaj +1 more source
Modelling the cutting forces in micro-end-milling using a hybrid approach [PDF]
, 2014 This paper presents the development of a cutting force model for the micro-end-milling processes under various cutting conditions using a hybrid approach.
Jing, Xiubing +3 more
core +1 more source
AIP Advances, 2017 In traditional diamond cutting, the cutting force is usually large and it will affect tool life and machining quality. Elliptical vibration cutting (EVC) as one of the ultra-precision machining technologies has a lot of advantages, such as reduces ...
Jieqiong Lin +4 more
doaj +1 more source
Energy Science & Engineering, 2022 Combining well‐drilling hammers with polycrystalline diamond compact bits to break rock under cutting load and impact load is an effective way to improve drilling efficiency.
Heng Zhang +6 more
doaj +1 more source
Research on Prediction Model of Conical Pick Cutting Force Based on Coulomb-Mohr Criterion [PDF]
MATEC Web of Conferences, 2020 Cutting force is one of the most important influence factors that affect the efficiency and service life of the conical pick. In order to accurately calculate the cutting force, through theoretical analysis and experimental research, a cutting force ...
Wang S.J., Zong X.M., He B., Kang K.X.
doaj +1 more source
Cutting Force Coefficients Determination Using Vibratory Cutting
Procedia CIRP, 2017 Abstract The paper presents determination of dynamic cutting force coefficients by direct measurements of instantaneous cutting forces during vibratory cutting. The method exploits a special test rig consisting of a dynamometer supported by flat springs.
Dominika Śniegulska-Grądzka +2 more
openaire +1 more source