Results 81 to 90 of about 7,476,610 (346)
Use of leaf thickness sensors in horticultural crops [PDF]
, 2017 Changes in leaf thickness can be a rapid indicator of the plant’s water status and can therefore serve as an alarm signal for potential water deficits. Combining the use of continuous leaf thickness measurements with a mechanistic plant model describing ...
De Pauw, Dirk +3 more
core +2 more sources
Molecular Oncology, EarlyView.CDK11 inhibition stabilises the tumour suppressor p53 and triggers the production of an alternative p21WAF1 splice variant p21L, through the inactivation of the spliceosomal protein SF3B1. Unlike the canonical p21WAF1 protein, p21L is localised in the cytoplasm and has reduced cell cycle‐blocking activity.
Radovan Krejcir +12 more
wiley +1 more source
Jixie qiangdu, 2015 A two-dimensional finite element model of orthogonal cutting Inconel 718 has been built by Third Wave Advant Edge to obtain the distribution of temperature and stress under different parameters of the cutting edge.
CHENG Xin +3 more
doaj
Numerical Analysis of the Influence of PDC Cutting Edge Radius on Temperature Distribution
Shiyou jixie, 2020 The temperature generated during the rock cutting process is the important factors that affect the cutting efficiency and service life of the cutter. The temperature distribution model of the interaction between the arc cutter and the rock is established.
Zheng Guojing +3 more
doaj
Molecular Oncology, EarlyView.Clinical trials on PARP inhibitors in urothelial carcinoma (UC) showed limited efficacy and a lack of predictive biomarkers. We propose SLFN5, SLFN11, and OAS1 as UC‐specific response predictors. We suggest Talazoparib as the better PARP inhibitor for UC than Olaparib.
Jutta Schmitz +15 more
wiley +1 more source
Modeling of temperature distribution in orthogonal cutting with dual-zone contact at rake face [PDF]
, 2012 In this study, an analytical model is developed in order to calculate the temperature distribution in orthogonal cutting with dual-zone contact at the rake face. The study focuses on heat generation at the primary shear zone and at the rake face.
Bakkal, Mustafa +5 more
core +1 more source
A comparison of two configurations for a dual-resonance cymbal transducer [PDF]
, 2018 The ability to design tuned ultrasonic devices that can be operated in the same mode at two different frequencies has the potential to benefit a range of applications, such as surgical cutting procedures where the penetration through soft then hard ...
Feeney, Andrew, Lucas, Margaret
core +1 more source
Influences of TiAlN Coating on Cutting Temperature during Orthogonal Machining H13 Hardened Steel
Coatings, 2019 TiAlN has been widely used in cutting tool coating due to its excellent mechanical and thermal performances. However, the research on the TiAlN coating effect on cutting temperature is not comprehensive enough.
Guangchao Hao +3 more
semanticscholar +1 more source
Cytoplasmic p21 promotes stemness of colon cancer cells via activation of the NFκB pathway
Molecular Oncology, EarlyView.Cytoplasmic p21 promotes colorectal cancer stem cell (CSC) features by destabilizing the NFκB–IκB complex, activating NFκB signaling, and upregulating BCL‐xL and COX2. In contrast to nuclear p21, cytoplasmic p21 enhances spheroid formation and stemness transcription factor CD133.
Arnatchai Maiuthed +10 more
wiley +1 more source
An atomistic simulation investigation on chip related phenomena in nanometric cutting of single crystal silicon at elevated temperatures [PDF]
, 2016 Nanometric cutting of single crystal silicon on different crystal orientations and at a wide range of temperatures (300-1500 K) was studied through molecular dynamics (MD) simulations using two sorts of interatomic potentials, an analytical bond order ...
Chavoshi, Saeed Zare, Luo, Xichun
core +1 more source