Results 41 to 50 of about 2,647,604 (292)
Drawing and re-drawing: Working with the physicality of the performing body in costume design [PDF]
, 2011 How does the act of drawing enable the costume designer to design costumes that work effectively with the physicality of the performing body? This research is located in the field of scenography and refers specifically to costume design practices ...
Gravestock, Hannah
core +5 more sources
The influence of drawing speed on structure changes in high carbon steel wires
Metalurgija, 2015 In the paper the influence of the drawing speed on structure changes has been assessed. The Scanning Electron Microscope investigation confirmed that for wires drawn with high total draft, exceeding 80 %, makes it impossible to clearly assess the impact ...
M. Suliga +3 more
doaj
FEBS Open Bio, EarlyView.Miniaturized flow chip platform enabling continuous perfusion and longitudinal multiphoton 3D imaging of vascular smooth muscle cell constructs under physiological flow. Brightfield imaging guides region selection, while CellTracker Green and mRuby‐labeled fetuin‐A visualize cells and mineral deposition, respectively. Magnesium supplementation markedly
Vytautas Kučikas +6 more
wiley +1 more source
FEBS Open Bio, EarlyView.Lactoferrin promotes wound healing by activating MAPK, PI3K/Akt, and extracellular matrix pathways, enhancing fibroblast remodeling, proliferation, and re‐epithelialization. These mechanisms highlight its therapeutic potential in inflammation control, tissue repair, and remodeling.
Morgana Lüdtke Azevedo +4 more
wiley +1 more source
Advances in Mechanical and Materials EngineeringThis article presents the results of the analysis of changes in the surface topography of AISI 321 (1.4541) thin-walled stainless steel tubes in single-pass Floating-Plug Drawing (FPD) process.
Krzysztof Żaba, Marcin Szpunar
doaj +1 more source
Archives of Metallurgy and Materials, 2017 The paper contains the theoretical and experimental analysis of the impact of the drawing angle on the drawing process and the properties of low carbon steel wires. A multi-stage drawing wire rod with a diameter of 5.5 mm on a wire with a diameter of 1.0
Suliga M., Wartacz R., Michalczyk J.
doaj +1 more source
FEBS Open Bio, EarlyView.NMR metabolomics revealed concentration‐dependent metabolic perturbations in HepG2 cells exposed to H2O2. Rifampicin pretreatment enhanced metabolic competence, attenuated toxin‐induced alterations and produced metabolite profiles more consistent with human liver physiology, supporting the use of CYP450‐induced HepG2 models for improved in vitro ...
Maren Jinks +4 more
wiley +1 more source
FEBS Open Bio, EarlyView.KDAC6 has been associated with cell motility and actin structures, but specific domain contributions are not established. The two catalytic domains have differential effects on motility and F‐actin regulation, affecting cortical F‐actin density, motility, stress fibers, and cell spreading.
Taylor V. Joseph +7 more
wiley +1 more source
Experimental Study on Fine Titanium Wire Drawing with Two Ultrasonically Oscillating Dies
IEEE Access, 2018 This paper investigates the influences of ultrasonic vibration on the two-pass titanium wire drawing process through experiments conducted at different drawing speeds (99–480 mm/s) and under various ultrasonic amplitudes (5.63– $13.97~\mu ...
Shen Liu +3 more
doaj +1 more source
Adenosine triphosphate as a modulator of protein interactions and stability
FEBS Open Bio, EarlyView.ATP is best known as the cell's energy currency, but it also shapes how proteins fold, interact, aggregate and form biomolecular condensates. This review explains the emerging physical principles behind these effects, including weak binding to charged protein regions, magnesium‐dependent behaviour and concentration‐dependent control of protein ...
Shuyuan Tan, Robin Curtis
wiley +1 more source