Results 11 to 20 of about 451,301 (277)
Evaluation of kiln-drying schedules for wild cherry wood (Cerasus avium) [PDF]
Wild cherry wood (Cerasus avium) lumber with a nominal thickness of 5 cm from Duzce region in Turkey was dried through conventional kiln drying using two different programs which are unprotective drying schedules, and protective drying schedules. The aim
Süleyman Korkut +4 more
doaj +6 more sources
Analysing the drying behavior of juvenile and mature Eucalyptus saligna wood in drastic drying test for optimal drying schedule [PDF]
The heterogeneity of characteristics observed in the pith-bark direction within a log causes sawn pieces of wood have different behaviors during water removal.
Bruno Charles Dias Soares +2 more
doaj +6 more sources
Changing the calculated surface area of wood samples to define drying schedules for Eucalyptus clones [PDF]
The aim of this study was to determine how varying the inputted surface area value of wood samples would affect the determination of kiln-drying schedules using the drastic drying test.
Daiane de Moura Borges Maria +4 more
doaj +2 more sources
DEVELOPMENT OF DRYING SCHEDULES FOR RUBBER AND PINE TIMBER FOR THE DEHUMIDIFICATION KILN DRYING [PDF]
Most of the limber in Sri Lanka is used in unseasoned state or seasoned using conventionalkilns which use fuel wood boilers or open fires as a heating source. A study has beenconducted to introduce dehumidification drying kiln. which is easy to fabricate andconsumes less energy hence ideal for small scale timber industries.
R. S. Sujith Rathnayake +1 more
openaire +3 more sources
This report presents result of a study on air drying properties and kiln drying schedule of ten wood species from Nusa Tenggara Barat. the study was carried out based On data from quick drying test.
Efrida Basri, Syarif Hidayat
doaj +2 more sources
Monitoring the moisture content (MC) of wood and avoiding large MC variation is a crucial task as a large moisture spread after drying significantly devalues the product, especially in species with high green MC spread. Therefore, this research aims to optimize kiln-drying and provides a predictive approach to estimate and classify target timber ...
Sohrab Rahimi +2 more
exaly +3 more sources
The aims of this research were to investigate the effects of interaction between incising densities and two drying schedules on drying rate and defects as well as to examine the effect of incising densities on static bending characteristics of dried ...
Tomy Listyanto +2 more
doaj +2 more sources
MECHANICAL PROPERTIES OF POPLAR WOOD (POPULUS ALBA) DRIED BY THREE KILN DRYING SCHEDULES
The influence of three drying schedules on the selected mechanical properties of poplar wood (Populus alba L.) was evaluated in terms of suitability for structural applications.
Mahdi Shahverdi, +4 more
doaj +1 more source
Measurement of colour development in Pinus radiata sapwood boards during drying at various schedules [PDF]
Colour changes, such as kiln brown stain, that develop in Pinus radiata boards during kiln drying can reduce the value of the final wood products and result in significant losses due to downgrade or waste of dried wood by removing the darkened surfaces ...
Murray McCurdy +2 more
doaj +2 more sources
EFFECTS OF SAWING PATTERN ON DRYING RATE AND RESIDUAL DRYING STRESSES OF PINUS RADIATA LUMBER
Flatsawn and quartersawn Pinus radiata (radiata pine) sapwood boards were dried in a tunnel dryer in three runs using three drying schedules. These schedules represented low temperature (LT), accelerated conventional temperature (ACT) and high ...
S Pang, A.N Haslett
doaj +2 more sources

