Results 161 to 170 of about 5,842 (216)
Some of the next articles are maybe not open access.

Three-stage six-pass EDFA preamplifier design and EDFA parameters’ optimization

Optical and Quantum Electronics, 2021
In this study, three-stage six-pass erbium doped fiber amplifier (EDFA) is performed. The mathematical model to characterize this proposed EDFA are also developed. During the design process, EDFA's input signal wavelengths, EDF lengths and pump powers are optimized.
Emrah Yigit, Murat Yucel
openaire   +2 more sources

S-EDFA and R-EDFA polarization properties comparison

Optics Communications, 2005
Experimental results on the behavior of the polarization state of the amplified optical signal for two configurations of erbium doped fiber amplifier: single pass erbium doped fiber amplifier (S-EDFA) and reflective erbium doped fiber amplifier (R-EDFA) employing a circulator and a faraday rotator mirror (FRM) are reported in this paper.
M.A. Quintela   +3 more
openaire   +1 more source

Dual-cavity Optical Gain Control for EDFAs and EDFA Cascades

Optical Amplifiers and their Applications, 1999
Optical wavelength-division-multiplexed networks will need provisions for partially altering the traffic at each repeater by adding/dropping some service channels.
Yongqian Liu   +2 more
openaire   +1 more source

Open EDFA gain spectrum dataset and its applications in data-driven EDFA gain modeling

Journal of Optical Communications and Networking, 2023
Optical networks satisfy high bandwidth and low latency requirements for telecommunication networks and data center interconnection. To improve network resource utilization, machine learning (ML) is used to accurately model optical amplifiers such as erbium-doped fiber amplifiers (EDFAs), which impact end-to-end system performance such as quality of ...
Zehao Wang   +2 more
openaire   +2 more sources

Noise measurements in EDFAs

Conference on Optical Fiber Communication, 1994
We propose a new parameter to describe the noise performance of erbium-doped fiber amplifiers (EDFAs). ft is based on the fact that the noise of a laser amplified by an EDFA is very similar (formally and substantially) to the noise of a laser with a higher relative intensity noise (RIN).
A. Cavaciuti, B. Sordo
openaire   +1 more source

Gain peaking in EDFAs

Conference on Optical Fiber Communication, 1994
In long-haul communications, erbium-doped fiber amplifiers (EDFAs) operate at a particular wavelength to produce the optimal level of dispersion. The gain spectrum of the ions can be used to filter the accumulated amplified spontaneous emission in such a system.1 To optimally use this autofiltering, the gain-peak wavelength (GPW) of the chain must ...
Paul F. Wysocki   +2 more
openaire   +1 more source

Broadband EDFA With Flat Gain Response

Conference on Lasers and Electro-Optics Europe, 1996
Dense WDM techniques in lightwave networks increase transmission capacity and improve system flexibility. Gain flatness of conventional EDFAs limits the number of WDM channels. Several techniques1,2 for EDFA gain equalization have been investigated, but with various shortcomings.
J.J. Pan, null Yuan Shi
openaire   +1 more source

Ultra-Low DMG Multimode EDFA

Optical Fiber Communication Conference, 2017
We demonstrate amplification in a multimode cladding-pumped fiber amplifier supporting 36 spatial modes. Using a large core EDF, we obtain
Zeinab Sanjabi Eznaveh   +12 more
openaire   +3 more sources

EDFAS 10 Year Anniversary: A Look Back at EDFAN → EDFA

EDFA Technical Articles, 2008
Abstract This article looks back on the ten-year history of Electronic Device Failure Analysis News and its transition to become Electronic Device Failure Analysis Magazine.
openaire   +1 more source

Wide-bandwidth EDFAs

Optical Amplifiers and Their Applications, 1997
The EDFA amplification band has been broadened and flattened as a matter of priority since the EDFA was first developed.
openaire   +1 more source

Home - About - Disclaimer - Privacy