Results 101 to 110 of about 31,024 (191)
An array of SiOx nanopillars is developed on ITO transparent rear contacts through nanoimprint lithography to promote light scattering in 500–600 nm bifacial ACIGS solar cells. This architecture increases the short‐circuit current density by 7.8 and 7.6 mA cm−2 under front (up to 36.2 mA cm−2) and rear illumination, respectively, offering a scalable ...
Enzo J. Ribeiro +11 more
wiley +1 more source
Amorphous SnO2 films with low resistivity (~1.2 × 10−3 Ωcm) were realized by low‐temperature magnetron sputtering through control of O2 flow ratio, substrate temperature, and H incorporation. Si heterojunction solar cells incorporating these films achieved a conversion efficiency of 21.1%, approaching that of cells based on MS‐ITO and RPD‐SnO2 ...
Takashi Koida +2 more
wiley +1 more source
Spectroscopic ellipsometry for photovoltaics
Spectroscopic ellipsometry has been applied to a wide variety of material and device characterizations in solar cell research fields. In particular, device performance analyses using exact optical constants of component layers and direct analyses of ...
Collins, Robert, Fujiwara, Hiroyuki
core +1 more source
Environmental pollution and water scarcity demand innovative purification methods. This study presents a sol‐gel approach to fabricate mixed silica–titania thin films joining photocatalytic activity with selective sorption capability. The films exhibit higher surface area, enhanced degradation of cationic and improved performance over bare titania ...
Andrea Lanfranchi +13 more
wiley +1 more source
Ellipsometry as a production measurement tool
Spectroscopic Ellipsometry is an enormously versatile measurement tool for surfaces and thin layers. We discuss the use of ellipsometry in the context of quality control in production processes of eletrconic ...
Hertwig, Andreas
core
The tailoring of the surface properties of cellulose nanocrystals (CNCs) to meet various requirements in environmental, food, and material areas has always been of great interest. In this study, the surface chemistry of CNCs was noncovalently modified by
Xiaoyu Gong +2 more
doaj +1 more source
This study visualizes the long‐term aging of lateral MoS2‐WS2 heterostructures stored under low‐vacuum condition using hyperspectral phase microscopy (HPM). While conventional techniques show limited sensitivity to ultrathin and amorphous oxidation products, HPM successfully reveals morphological and optical changes during aging. Optical modeling using
Yoojoong Han +5 more
wiley +1 more source
Electro - total internal reflection ellipsometry has been reported as a phase sensitive ellipsometry technique to observe the redox reactions on the surface of the electrode.
Ma HW +16 more
core +1 more source
We study the dependence of the optical response of square lattices of plasmonic nanoparticles on the mutual orientation of the lattice and the plane of incidence of illuminating light.
Eugene Bortchagovsky +10 more
doaj +1 more source
Impact of co‐reactants and their doses utilized during the atomic layer deposition of SnOx on perovskite/C60 structures on the performance of p‐i‐n perovskite solar cells. ABSTRACT Although tin oxide (SnOx) layers grown using atomic layer deposition (ALD) are routinely employed in p‐i‐n perovskite solar cells (PSCs), the correlation between ALD process
Bhavya Rakheja +12 more
wiley +1 more source

