Results 31 to 40 of about 9,816,824 (299)
Diagnosis and fault tolerant control against actuator fault
Measurement + Control, 2023 Over the past few decades, there have been increasing research activities in fault diagnosis (FD) and fault-tolerant control (FTC) for switched hybrid systems.
Yahia Salwa +2 more
doaj +1 more source
Energies, 2022 Aiming at the open circuit fault of a dual three-phase permanent magnet synchronous motor, a normalized current method is used for open circuit fault diagnosis.
Liping Zhao +3 more
doaj +1 more source
CONTROLLERS FOR FAULT TOLERANT ACTUATORS
Aviation, 2007 The Fly‐by‐Wire technology enables flexible shaping of both effective dynamics and handling qualities of aircraft. This solution extends aircraft possibilities and supports the pilot by use of high‐level control laws. Application of FBW for aircraft would make flying both safer, and more popular. On the other hand the FBW system must be highly reliable.
Dołega, Bogusław, Rzucidło, Paweł
openaire +3 more sources
A desktop environment for assessment of fault diagnosis based fault tolerant flight control laws [PDF]
, 2008 We present a simulation based software environment conceived to allow an easy assessment of fault diagnosis based fault tolerant control techniques. The new tool is primary intended for the development of advanced flight control applications with fault ...
Gertjan Looye +5 more
core +1 more source
End-to-End Deep Fault-Tolerant Control [PDF]
IEEE/ASME Transactions on Mechatronics, 2022 PUBLISHED ON IEEE/ASME TRANSACTIONS ON MECHATRONICS, DOI: 10.1109/TMECH.2021.3100150. Ideally, accurate sensor measurements are needed to achieve a good performance in the closed-loop control of mechatronic systems. As a consequence, sensor faults will prevent the system from working correctly, unless a fault-tolerant control (FTC) architecture is ...
Daulet Baimukashev +3 more
openaire +3 more sources
Fault Detection in High Redundancy Actuation Using an Interacting Multiple-Model Approach [PDF]
, 2009 The High Redundancy Actuation (HRA) project investigates the use of a relatively high number of small actuation elements, assembled in series and parallel in order to form a single actuator which has intrinsic fault tolerance.
Thomas Steffen (1252947) +20 more
core +1 more source
Fault estimation and fault-tolerant control for discrete-time dynamic systems [PDF]
, 2015 In this paper, a novel discrete-time estimator is proposed, which is employed for simultaneous estimation of system states, and actuator/sensor faults in a discrete-time dynamic system.
Gao, Zhiwei
core +1 more source
In-the-Loop Simulation Experiment of Aero-Engine Fault-Tolerant Control Technology
Applied Sciences, 2022 Aeroengines are prone to failure due to their large range of working envelopes and bad working environments. Fault diagnosis and a fault-tolerant control strategy for aeroengines and control systems are important means to improve the reliability of ...
Mengtian Zhang +3 more
doaj +1 more source
Design and assessment of a multiple sensor fault tolerant robust control system [PDF]
, 2008 This paper presents an enhanced robust control design structure to realise fault tolerance towards sensor faults suitable for multi-input-multi-output (MIMO) systems implementation.
Chen, J +5 more
core +1 more source
EMS Systems: Optimised Sensor Configurations for Control and Sensor Fault Tolerance [PDF]
, 2009 The paper describes a sensor optimisation systematic framework approach and a Fault Tolerant control scheme for sensor failures applied to an EMS maglev system.
Michail, Konstantinos +5 more
core +3 more sources