Results 81 to 90 of about 3,742,515 (329)
Fluid-solid coupling characteristics analysis for tripod sliding universal joints
, 2019 Fluid-solid coupling theory is introduced into tripod sliding universal joint design. The geometric models of the tripod sliding universal joint and lubricant film are established respectively and meshed.
Linlin Sun +3 more
core +1 more source
Analysis of added mass in cavitating flow [PDF]
, 2012 The paper addresses a theoretical study of the added mass effect in cavitating flow.The cavitation is considered to induce a strong time–space variation of the fluid density at the interface between an inviscid fluid and a three-degree-of-freedom rigid ...
BENAOUICHA, Mustapha +1 more
core +1 more source
Stability of mud-water interface under long surface waves
AIP Advances, 2019 Fluid mud often exists in coastal areas with an interface separating it from its upper water layer. When a surface wave propagates over a bed covered with water and fluid mud, it will cause an interfacial wave of the mud-water interface, which damps the ...
Jiebin Liu, Jifu Zhou
doaj +1 more source
Case Studies in Thermal Engineering, 2019 This work presents a case study of the relationship between temperature and cooling effectiveness of a film-cooled vane under effect of coolant inlet temperature in two aspects based on the actual and base coolant inlet temperatures.
Prasert Prapamonthon +3 more
doaj +1 more source
Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying
Advanced Engineering Materials, EarlyView.An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara +8 more
wiley +1 more source
Superconfinement tailors fluid flow at microscales. [PDF]
, 2015 Understanding fluid dynamics under extreme confinement, where device and intrinsic fluid length scales become comparable, is essential to successfully develop the coming generations of fluidic devices.
Aarts, Dirk G. +16 more
core +1 more source
Intrinsic relationship of vorticity between modes A and B in the wake of a bluff body
Theoretical and Applied Mechanics Letters, 2018 The intrinsic physical relationship of vorticity between modes A and B in the three-dimensional wake transition is investigated. Direct numerical simulations for the flow past a square-section cylinder are carried out at Reynolds numbers of 180 and 250 ...
L.M. Lin, S.Y. Shi, Y.X. Wu
doaj +1 more source
International Journal of Naval Architecture and Ocean Engineering, 2020 Based on laboratory experiments and numerical simulations, the scale effect of Internal Solitary Wave (ISW) loads on spar platforms is investigated. First, the waveforms, loads, and torques on the spar model at a laboratory obtained by the experiments ...
Xu Wang, Ji-Fu Zhou
doaj +1 more source
Development of a moving model rig with a large Reynolds number and measurement of aerodynamic drag
Engineering Reports, 2022 The principles and techniques for developing a moving model rig (MMR) driven by compressed air were introduced for moving model tests at large Reynolds numbers (≥106).
Qiansuo Yang
doaj +1 more source
Modular Critical Element Recycling Platform Using a Nanoporous Additively Manufactured Gyroid
Advanced Engineering Materials, EarlyView.A modular recycling platform integrates 3D‐printed nanoporous gyroid structures to enable efficient critical element recovery. This system utilizes a hierarchical architecture, combining macroscopic channels with polymerization‐induced nanoscale porosity. By systematically tuning structural wall thickness and resin formulation, the platform achieves an
Xiangyu Gao +6 more
wiley +1 more source