Results 31 to 40 of about 78,627 (246)

Effervescent Tablet Preparation by Twin-Screw Melt Granulation with Sorbitol as a Melt Binder

Pharmaceutics
Methods: Effervescent granules containing citric acid and sodium bicarbonate were successfully prepared for the first time via TS-MG using a polyol (sorbitol) as a melt binder.
Zoltán Márk Horváth, Kirils Kukuls, Alīna Jaroslava Frolova, Marta Žogota, Elżbieta Maria Buczkowska, Līga Pētersone, Valentyn Mohylyuk   +6 more
doaj   +1 more source

The treatment of high strength protein wastewater by UASB system [PDF]

Songklanakarin Journal of Science and Technology (SJST), 2006
The objective of this investigation was to treat the high strength protein wastewater by UASB system. The wastewater of this experiment had COD 2,938 mg/l, SS 478 mg/l and total of nitrogen 435 mg/l.
Ploypatarapinyo, P., Natpinit, S., Jenvanitpanjakul, P.   +2 more
doaj  

Improving the sintering performance of specularite bearing mixtures by separated pre-agglomeration-sintering processes

工程科学学报, 2015
For the characteristics of weak ballability and inferior amenability of specularite concentrates, the granulating and sintering performances of imported specularite were investigated by two kinds of separated pre-agglomeration-sintering processes ...
ZHU De-qing, ZHONG Yang, PAN Jian
doaj   +1 more source

Preparation of feedstock for potassium chloride granulation plants

Весці Нацыянальнай акадэміі навук Беларусі: Серыя фізіка-тэхнічных навук
The assessment of existing technological solutions in the field of preparation of feedstock for potassium chloride granulation plants of silvinite processing plants of JSC “Belaruskali”, compliance of these solutions with the developed theoretical ...
O. M. Volchek, V. Ya. Prushak
doaj   +1 more source

THE STUDY OF THE KINETIC OF NATURAL ZEOLITE GRANULES GROWTH AT DIFFERENT WAYS OF GRANULATION [PDF]

Annals of Mechnikov's Institute, 2016
Introduction. Active substances and excipients used in the manufacture of medicines in tablet form, in most cases, have poor technological properties. This fact determines the need for prior granulation of mass before compression.
Rybachuk VD
doaj   +1 more source

Manufacturing Continuous Fiber‐Reinforced Printing Filaments: Development of a Post‐Consolidation Unit

Advanced Engineering Materials, EarlyView.
A novel, temperature‐controlled post‐consolidation unit is developed to test its potential to improve the melt impregnation process used to manufacture continuous fiber‐reinforced filaments for additive manufacturing of high‐performance thermoplastics.
Daniel Beermann, Patrick Schiebel, David May   +2 more
wiley   +1 more source

Unidirectional Tape‐Based Composites from Hemp and Pineapple Leaf Fiber: Mechanical Performance in Conventional and Bio‐Based Matrices

Advanced Engineering Materials, EarlyView.
The study investigates novel semi‐finished products made of unidirectionally arranged hemp or pineapple leaf fiber‐reinforced composites produced from different matrices. The materials are analyzed in terms of their mechanical and interfacial properties and void content.
Nina Graupner, Raja Bade, Valentin Ackermann, Roja M. Baumann, Corvin Bischoff, Jona F. Ebeling, Oskar Glenz, Marlo Groh, Jonathan Groth, Finja Hiller, Tom Hirschmüller, Felix Menke, Syntcha Ngantchou Lecdou, Mika Ohler, Daniel Rafii Vardiny, Darius Richter, Dario Röper, Henrik Schumacher, Theresa Stein, Benjamin Vorbeck, Elisabeth Wermter, Kay Kölzig, Jörg Müssig   +22 more
wiley   +1 more source

Rapid Nondestructive Detection of Water Content and Granulation in Postharvest “Shatian” Pomelo Using Visible/Near-Infrared Spectroscopy

Biosensors, 2020
Visible/near-infrared (VIS/NIR) spectroscopy is a powerful tool for rapid, nondestructive fruit quality detection. This technology has been widely applied for quality detection of small, thin-peeled fruit, though less so for large, thick-peeled fruit due
Sai Xu, Huazhong Lu, Christopher Ference, Guangjun Qiu, Xin Liang   +4 more
doaj   +1 more source

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

Characterization of a Recyclate‐Based MgO‐Steel Composite As‐Sintered Inert Anode Candidate After Exposure to Cryolite Electrolysis

Advanced Engineering Materials, EarlyView.
Carbon‐free inert anodes are essential for decarbonizing aluminum electrolysis. This study investigates a recyclate‐based MgO‐316L steel composite anode tested under galvanostatic Hall–Héroult conditions in cryolite at 1000°C. Microstructural analysis reveals selective MgO fluorination, spinel and oxide layer formation, electrolyte infiltration, and ...
Serhii Yaroshevskyi, Alexander Adamczyk, Nora Brachhold, Gert Schmidt, Jana Hubálková, R. Gumeniuk, Alexandros Charitos, Christos G. Aneziris   +7 more
wiley   +1 more source