Results 71 to 80 of about 38,287 (265)

Receptor‐Free Identification of Toxic Gases Enabled by Hygroscopic Aqueous Salt Films

Advanced Functional Materials, EarlyView.
Water as a gas sensor coating sounds impossible—until it stops evaporating. Here, hygroscopic salt solutions (LiCl, LiBr, H3PO4) form non‐drying aqueous films on CNT chemiresistors under ambient air. Gases partition into these liquid layers, sometimes transforming into water, and generate salt‐specific resistance fingerprints across a four‐channel ...
Seongwoo Lee, Yun‐Tae Kim, Hwarang Choi, Sanghwan Park, Seongyeop Lim, Chang Young Lee   +5 more
wiley   +1 more source

Regulated Ion‐Diffusion Hydrogels for Subtle and Multimodal Temperature‐Strain Sensing in Wound Monitoring

Advanced Functional Materials, EarlyView.
A soft, dual‐channel hydrogel patch enables simultaneous detection of wound temperature and strain by integrating ion‐diffusion‐mediated thermoelectric and resistive sensing. The conformal design maintains stable performance during motion, capturing subtle inflammatory and mechanical changes for continuous wound monitoring.
Yu Fang, Xinglong Pan, Zhiwei Li, Wanheng Lu, Chang Liu, Yi Zhou, Guo Tian, Ghim Wei Ho   +7 more
wiley   +1 more source

A Study on Thermal Compression Deformation and Structure of 700 MPa Pipeline Steel

Teshugang, 2018
With using Gleeble-3500 thermal simulator the single pass hot compression deformation and structure evolution of 20 mm hot-rolled plate of 700 MPa pipeline steel (/%: 0.07C, 0.90Si, 0.60Mn, 0.008P, 0.002S, 0.30Ni, 0.10Cr, 0.12Mo, 0.06V, 0.03Nb, 0.28Cu, 0.
杨秀芝, 华文林, 杨春杰, 董春法, 肖新华   +4 more
doaj  

Spin Injection Of Exciton–Polaritons With Halide Perovskites At Room Temperature

Advanced Functional Materials, EarlyView.
A monolithic Tamm‐plasmon microcavity embedding a two‐dimensional halide perovskite enables room‐temperature spin injection of exciton‐polaritons under quasi‐resonant optical excitation. Polarization‐resolved spectroscopy reveals partial preservation of the injected spin in the lower polariton branch, while bare excitons remain fully depolarized.
Elena Sendarrubias Arias‐Camisón, Maksim Lednev, Jorge Cuadra, Raúl Gago, Luis Viña, Francisco José García Vidal, Johannes Feist, Ferry Prins, Carlos Antón Solanas   +8 more
wiley   +1 more source

Development of a Three‐Axis Planar Hall Magnetoresistance Sensor Using a Superparamagnetic Nanoparticle‐Based Flux Guide

Advanced Functional Materials, EarlyView.
A printed superparamagnetic nanoparticle‐based flux guide enables the realization of a hysteresis‐free three‐axis magnetic sensor. This innovative architecture efficiently redirects out‐of‐plane fields to planar sensing elements, facilitating simultaneous vector detection without complex reset protocols.
Changyeop Jeon, Mijin Kim, Keonmok Kim, Byeonghwa Lim, Bibhutibhusan Nayak, Youngdo Jung, Bo‐Yeon Lee, Taehyeong Jeon, Jinwoo Kim, Sunjong Oh, CheolGi Kim   +10 more
wiley   +1 more source

The Portevin-Le Chatelier Effect of Cu-2.0Be Alloy during Hot Compression. [PDF]

Materials (Basel), 2023
Zhu D, Wu N, Liu Y, Liu X, Jiang C, Jiang Y, Zhao H, Cui S, Xie G.   +8 more
europepmc   +1 more source

Non‐Monotonic Changes in the Thermal Conductivity of Conjugated Polymer Films with Increasing Levels of Chemical Doping

Advanced Functional Materials, EarlyView.
Thermal conductivity changes non‐monotonically as regioregular (RR) and regiorandom (RRa) P3HT films are doped with F4TCNQ as a function of the extent to which P3HT is doped: an increase in thermal conductivity is observed upon lightly doping P3HT compared to the undoped film, followed by a decrease in the heavily doped regime. ABSTRACT The performance
Reid W. Wilson, Xinping Shi, Diego Garcia Vidales, Abigail Slimp, Zerina Mehmedović, Alexander F. Simafranca, Eric C. Wu, Sarah H. Tolbert, Richard B. Wilson, Benjamin J. Schwartz   +9 more
wiley   +1 more source

Electrospun Wood‐Derived Biopolymers as Electrodes in Electrochemical Energy Storage Technologies

Advanced Functional Materials, EarlyView.
Electrospinning transforms wood‐derived cellulose and lignin into architecturally defined, binder‐free carbon electrodes with tuneable porosity and functionality. This review shows how fibre design enables decoupled charge and mass transport, enhancing performance across battery systems, while identifying key challenges in spinnability, scalability ...
Michael W. Thielke, Hattie R. Chisnall, Jesus Vazquez Chavez, Ana B. Jorge Sobrido   +3 more
wiley   +1 more source

Single‐Step Recovery of Water from Stable Crude Oil‐Water Emulsion Using Surface Engineered Hybrid Inorganic‐Polymer Membranes

Advanced Functional Materials, EarlyView.
Atomic layer deposition is used to conformally surface engineer polymeric membranes to fabricate inorganic–organic hybrid membranes. These membranes have exceptionally strong attraction toward water even in high oil containing emulsions, which leads to an extremely strong hydration layer at the interface.
Bratin Sengupta, Yining Liu, Gaurab Sarkar, Rouke Cai, Katrina Sparks, Chi Thang Nguyen, Tamar Segal‐Peretz, Seth B. Darling, Jeffrey W. Elam   +8 more
wiley   +1 more source

EVALUATING HOT DEFORMATION BEHAVIOR OF W360 TOOL STEEL BY HOT COMPRESSION TEST

Journal of Advanced Materials in Engineering, 2021
In this research, the hot deformation behavior of W360 tool steel was investigated using hot compression test at 1000-1200°C and strain rates of 0.001, 0.01, 0.1, and 1 s-1. According to the results, dynamic recrystallization was found the most important
R. Amirarsalani, M. Morakabati, R. Mahdavi   +2 more
doaj