Constructing a Superior Interfacial Microstructure on Carbon Fiber for High Interfacial and Mechanical Properties of Epoxy Composites [PDF]
Nanomaterials, 2022 The interface quality is crucial for the properties of carbon fiber-reinforced polymer- matrix composites (CFRPs). In order to improve the interfacial and mechanical properties of CFRPs, a superior gradient modulus interfacial microstructure is ...
Ping Han +3 more
doaj +5 more sources
Journal of Magnesium and Alloys, 2020 In this study, an overcasting process followed by a low-temperature (200°C) annealing schedule has been developed to bond magnesium to aluminum alloys. ProCAST software was used to optimize the process parameters during the overcasting process which lead
Ziang Zhu +4 more
doaj +3 more sources
Enhanced flow sensing with interfacial microstructures [PDF]
Biosurface and Biotribology, 2020 Biological flow receptors show astonishing performance and are used as models for the design of novel flow sensors. However, the functional importance of interfacial microstructures is seldom discussed in previous review papers. Herein, this review summarises the underlying biomechanical principles in the biological flow receptors and describes the ...
Yonggang Jiang +5 more
openaire +3 more sources
Effects of impurities on alumina–niobium interfacial microstructures [PDF]
Materials Characterization, 2006 Optical microscopy, scanning electron microscopy, and transmission electron microscopy were employed to examine the interfacial microstructural effects of impurities in alumina substrates used to fabricate alumina-niobium interfaces via liquid-film-assisted joining.
McKeown, Joseph T. +3 more
openaire +3 more sources
Interfacial microstructure evolution in fusion welding of immiscible Mg/Fe system
Materials & Design, 2019 Immiscible dissimilar metals can be successfully bonded by adding alloying elements to promote interfacial reaction. Although there are many kinds of interfacial microstructure, studies on the interfacial microstructure evolution are deficient under ...
Taotao Li +3 more
doaj +3 more sources
Interfacial microstructure in Y1Ba2Cu3O7-δ high Tc superconductors
, 1990 The microstructures of YBa2Cu3O7-δ ceramics prepared from freeze dried powders and containing an excess of CuO have been studied by analytical electron microscopy. Special attention has been paid to the interfacial microstructure.
Dunlop, G.L. +3 more
core +3 more sources
Interfacial Microstructure of Ni/Si-Based Ohmic Contacts To GaN
, 1998 The microstructure of Ni/Si-based contacts to GaN has been studied using transmission electron microscopy methods. The transition from non-ohmic to ohmic behavior appears to correlate with the initial limited reaction of GaN with Ni and further Si-Ni ...
Kamińska, E. +7 more
core +2 more sources
Effect of Copper on Interfacial Reaction and Microstructure of Soldering on Aluminum Substrate
Journal of Materials Research and TechnologyInterfacial reactions and microstructure evolution of Al/Sn-3.5mass%Ag (SA)/Al, Al/Sn-3.0mass%Ag-0.5mass%Cu (SAC305)/Al, and Cu/SA/Al joints were investigated in this study. The microstructure of the intermetallic compound (IMC) was studied at soldering temperature of 250 °C and a thermal aging temperature of 150 °C for 100, 300, and 1000 h.
Jiahui Li +5 more
openaire +3 more sources
THE INTERFACIAL MICROSTRUCTURE OF SiC-WHISKER REINFORCED Si3N4
, 1990 The fine scale interfacial microstructure of SiC whisker reinforced Si3N4 composites has been studied using analytical electron microscopy. The composites have been prepared in two different ways, by hot pressing and by nitrided pressureless sintering ...
G. L. DUNLOP +3 more
core +3 more sources
Effect of Brazing Temperature and Holding Time on the Interfacial Microstructure and Properties of TC4-Brazed Joints with Ti-Zr-Cu-Ni Amorphous Filler. [PDF]
Materials (Basel)Wu Y, Li J, Wang Z, Lu S, Liu K.
europepmc +3 more sources