Results 41 to 50 of about 106 (70)
The application of machine learning (ML) in structural engineering is receiving increasing attention recently. This paper experimentally studies three self-restoring reinforced concrete (SRRC) columns reinforced with low-bond ultra-high strength rebars ...
Yue Wen, Gaochuang Cai, Prafulla Malla
doaj +1 more source
High-strength steel (HSS) is increasingly used in modern structures because of its high strength-to-weight ratio. However, existing design standards based on the Effective Width Method (EWM) and section classification can be conservative for S690 and ...
Jun Ma, Li Gu, Yi Zhou, Yuanzhi Zhang
doaj +1 more source
Cyclic testing of a steel-tube-enabled emulative precast column-to-column connection
Precast systems are increasingly favored in modern construction to meet the growing demands for faster project delivery, cost control, and enhanced quality assurance.
Ming-Ming Ji +5 more
doaj +1 more source
Reinforced concrete columns constructed prior to the 1970s often exhibit deficient lap splices at the base, characterized by insufficient splice lengths.
Yuheng Zhao +3 more
doaj +1 more source
Seismic Performance of Precast Steel Beam-Column Joint with Bolted Connection
This paper introduces a modular, assembled steel beam-column flange connection joint that efficiently connects prefabricated beams and columns using high-strength bolts.
Yandan Chen, Yonggang Lu, Tong Liu
doaj +1 more source
This study presents an analytical investigation and a parametric evaluation of the structural behavior and seismic performance of highly corroded reinforced concrete (RC) columns, based on previously conducted experimental studies by the authors.
Alper Çelik +3 more
doaj +1 more source
Existing reinforced concrete buildings generally exhibit limited resistance in the failure limit state, primarily due to inadequate reinforcement detailing that does not satisfy modern seismic design requirements, whereas they show adequate resistance in
John Bellos, Apostolos Konstantinidis
doaj +1 more source
Due to the unique structural characteristics of the SCOPE joint, U-shaped rebars need to be lapped within the keyway region to realise force transfer of the joint in the plastic-hinge zone.
WANG Suguo +4 more
doaj +1 more source
Seismic strategy of non-seismically designed reinforced concrete columns retrofitted with steel rods
This paper presents experimental results of combined cyclic load testing on a reinforced concrete (RC) column that was retrofitted with newly designed steel rods. The steel rods were installed around the column longitudinally and then anchored.
Min Sook Kim, Young Hak Lee
doaj +1 more source
Effects of End plate Stiffener on Behavior of Extended End-plate Beam-to-column Connections
:In order to analyze the influences of different stiffeners on joint performances in extended end plate connections, the finite element method with large and elasto-plastic deformation, suited to contact problems, was used.
doaj

