Results 61 to 70 of about 1,540,265 (278)
Electrochemical, localized electrochemical and surface exploration procedures were used to investigate the potential of wings plucked from adult cockroaches (WAC) to attenuate N80 steel corrosion in simulated saltwater. According to the impedance studies,
Shivani Singh +3 more
doaj +1 more source
In recent years, the investigation of the complex interplay between the nanostructure and photo-transport mechanisms has become of crucial importance for the development of many emerging photovoltaic technologies.
Pablo A. Fernández Garrillo +2 more
doaj +1 more source
Control of bilayer polyelectrolyte coating parameters using the Kelvin probe microscopy [PDF]
В работе исследовалось бислойное покрытие полиэтиленимин/глюкозооксидаза на поверхности Si/SiO2 методом Кельвин-зонд силовой микроскопии (КЗСМ). При помощи КЗСМ удалось определить влияние освещения и типа проводимости Si на количество адсорбированных ...
Kozlowski, A. V. +3 more
core
Characterization of block copolymers using scanning probe microscopy
Block copolymers have attracted lots of attention in recent years for various nanoscience and nanotechnology applications. One common technique for characterization of block copolymer thin films is scanning probe microscopy.
Wang, H, Djurisic, AB, Chan, WK, Xie, MH
core +1 more source
Stepwise dual‐side functionalization creates covalent Janus graphene with chemically and electrostatically asymmetric interfaces. The resulting nonadditive surface‐potential response and pronounced charge‐transport modulation demonstrate a versatile route for tailoring the electronic properties of graphene.
Shishi Liu +14 more
wiley +1 more source
In quasi binary systems like AgBr–NaBr the demixing from the homogeneous high temperature phase into separated phases is a complex process that depends on the ageing temperature as well as on the quench rate.
F Güthoff, B Zhang, G Eckold
doaj +1 more source
Calibration of the scanning Kelvin probe force microscope under controlled environmental conditions [PDF]
Local Volta potential differences (Δψ) between a platinum coated AFM tip and various pure metal specimens with a thin humidity induced surface electrolyte layer have been determined via scanning Kelvin probe force microscopy (SKPFM).
Cook, A. B. +7 more
core +1 more source
Dual Single Atoms Boosting Photocatalytic Upcycling of Raw Polyvinylidene Fluoride Plastic
To resolve the catastrophic disaster of plastic contamination, the Cu‐Fe dual‐single‐atom‐loaded In2P3S9 NSs photocatalyst was prepared for direct conversion of raw polyvinylidene fluoride plastic into valuable chemicals. The dual‐single‐atom catalyst exhibits exceptional performance, with a total acetic/formic acid production of ∼1351.8 µmol g−1 ...
Amin Talebian‐Kiakalaieh +6 more
wiley +1 more source
Soft dielectric elastomer composites often face a trade‐off between enhanced dielectric properties and mechanical compliance. Here, a parallel‐aligned polyurethane nanofiber network embedded in PDMS creates a flexible, durable composite with increased permittivity, low modulus, and fatigue stability after 100,000 cycles.
Yi Ge +9 more
wiley +1 more source
A Duality Between Surface Charge and Work Function in Scanning Kelvin Probe Microscopy
Scanning Kelvin probe microscopy (SKPM) is a powerful technique for macroscopic imaging of the electrostatic potential above a surface. Though most often used to image work‐function variations of conductive surfaces, it can also be used to probe the ...
Isaac C.D. Lenton +3 more
doaj +1 more source

