Results 1 to 10 of about 771,500 (119)

Successive neutron and gamma irradiation and their impact on the characteristics of solar cells [PDF]

open access: yesNuclear Technology and Radiation Protection, 2022
This study investigates the effects of successive neutron and gamma radiation on the parameters of commercial solar cells. Several solar panels have been exposed to neutron radiation and then, after 30 days of recovery, to gamma radiation.
Nikolić Dejan S.   +1 more
doaj   +1 more source

Analytical Modeling of the Maximum Power Point with Series Resistance

open access: yesApplied Sciences, 2021
This paper presents new analytical expressions for the maximum power point voltage, current, and power that have an explicit dependence on the series resistance.
Alfredo Sanchez Garcia, Rune Strandberg
doaj   +1 more source

Feasibility of Photovoltaic Module Single-Diode Model Fitting to the Current–Voltage Curves Measured in the Vicinity of the Maximum Power Point for Online Condition Monitoring Purposes

open access: yesEnergies, 2022
Photovoltaic system condition monitoring can be performed via single-diode model fitting to measured current–voltage curves. Model parameters can reveal cell aging and degradation.
Heidi Kalliojärvi   +2 more
doaj   +1 more source

Investigation of X-ray radiation response to electrical properties of Mo/Cu(In0.7Ga0.3)Te2/p-Si/Al semiconductor diode

open access: yesJournal of New Results in Science, 2023
Diodes are exposed to radiation in many operating environments, and it is important to investigate the radiation effect. In this study, the impact of X-ray radiation on the electrical properties of Mo/Cu(In0.7Ga0.3)Te2/p-Si/Al semiconductor diode was ...
Güven Çankaya   +2 more
doaj   +1 more source

Adjusting the Single-Diode Model Parameters of a Photovoltaic Module with Irradiance and Temperature

open access: yesEnergies, 2020
This paper presents a concise discussion and an investigation of the most literature-reported methods for modifying the lumped-circuit parameters of the single-diode model (SDM) of a photovoltaic (PV) module, to suit the prevailing climatic conditions of
Nader Anani, Haider Ibrahim
doaj   +1 more source

Cost‐effective energy harvesting at ultra‐high concentration with duplicated concentrated photovoltaic solar cells

open access: yesEnergy Science & Engineering, 2020
Concentrated photovoltaic (CPV) systems are one of the few technologies that can provide cost reduction while offering efficiency improvement. In this respect, the resistive losses are some of the main limiting factors, which restrict the efficiency ...
Mohamed El‐Gahouchi   +4 more
doaj   +1 more source

Effect of Annealing Atmosphere on the Diode Behaviour of ZnO/Si Heterojunction

open access: yesElektronika ir Elektrotechnika, 2021
The effect of thermal annealing atmosphere on the electrical characteristics of Zinc oxide (ZnO) nanorods/p-Silicon (Si) diodes is investigated. ZnO nanorods are grown by low-temperature aqueous solution growth method and annealed in Nitrogen and Oxygen ...
Sadia Muniza Faraz   +5 more
doaj   +1 more source

Series Resistance Reduction in Stacked Nanowire FETs for 7-nm CMOS Technology

open access: yesIEEE Journal of the Electron Devices Society, 2016
Vertically stacked nanowire field effect transistors currently dominate the race to become mainstream devices for 7-nm CMOS technology node. However, these devices are likely to suffer from the issue of nanowire stack position dependent drain current. In
Anil Kumar Bansal   +3 more
doaj   +1 more source

Non-Uniform Spline Quasi-Interpolation to Extract the Series Resistance in Resistive Switching Memristors for Compact Modeling Purposes

open access: yesMathematics, 2021
An advanced new methodology is presented to improve parameter extraction in resistive memories. The series resistance and some other parameters in resistive memories are obtained, making use of a two-stage algorithm, where the second one is based on ...
María José Ibáñez   +4 more
doaj   +1 more source

Simulation of Series Resistance Increase through Solder Layer Cracking in Si Solar Cells under Thermal Cycling

open access: yesEnergies, 2023
In solar cell modules, thermal cycling stresses can cause cracking in the ribbon wire, leading to an increase in series resistance and a drop in the power output of the module.
Changwoon Han
doaj   +1 more source

Home - About - Disclaimer - Privacy