Results 61 to 70 of about 138,361,326 (265)
Heat transfer analysis for phase change materials (PCMs) [PDF]
, 2009 The heat transfer enhancement for phase change materials (PCMs) has received much attention nowadays, since most of PCMs have low thermal conductivities which prolong the charging and discharging processes.
Zhao, Changying, Tian, Y. (Yuan)
core
Advanced Materials Interfaces, EarlyView.Interfacial charge transfer and low‐resistance interphase formation between PEO‐based polymer and Li10GeP2S12 solid electrolytes are investigated using multi‐electrode impedance spectroscopy and advanced analytical techniques such as XPS and ToF‐SIMS.
Ujjawal Sigar +6 more
wiley +1 more source
Heat transfer properties of porous materials and insulants [PDF]
, 1984 Buildings are complex thermally-dynamic structures serving aesthetic as well as, utilitarian functions. It is essential that careful planning is undertaken if buildings are to be energy efficient and cheap to run throughout their-expected life-spans ...
Batty, William J.
core +2 more sources
Sustainable Plant‐Based Water Repellent Coatings Using Hydrophobic Pine and Palm Pollen
Advanced Materials Interfaces, EarlyView.A novel formulation strategy for creating superhydrophobic coatings using plant‐derived waxes and chemically treated pine and palm pollen. By employing acid modification, the hydrophobicity of the pollen surface is enhanced, resulting in water contact angles exceeding 150°.
Brenda Resendiz‐Diaz +2 more
wiley +1 more source
Advanced Materials Interfaces, EarlyView.The thermal budget imposed during oxide passivation is revealed as a key design parameter for Pt resistance temperature detectors in Organ‐on‐a‐Chip platforms. By establishing a direct processing–microstructure–device performance relationship, this work transforms an unavoidable fabrication step into a strategy for reliable integrated temperature ...
Gabriel M. Ferreira +4 more
wiley +1 more source
Thermal Enhancement of TADF‐OLED Performance: Size of Active Area Matters
Advanced Materials Interfaces, EarlyView.Large‐area TADF‐based OLEDs can be used as thermally assisted light‐emitting devices, in which moderate waste heat can partially compensate for efficiency losses associated with increasing active area. ABSTRACT Temperature significantly impacts the performance of light‐emitting diodes, typically causing degradation as they heat up. However, OLEDs using
Demyd V. Pekur +9 more
wiley +1 more source
Assessment of downhole heat exchangers in Puna district, Hawaii
, 2007 "Downhole heat exchangers (DHEs) have the potential for use in direct (non-electric) applications of geothermal energy. Their benefit is that no groundwater is extracted from wells.
Geo-Heat Center, Oregon Institute of Technology
core +2 more sources
Natural Convection in a Cylindrical Cavity Heated by an Internally-Located Strong Source
Engineering Transactions, 1993 Stationary natural! convection caused by a strong source of beat centrally located in a cylindrical cavity is analyzed by a finite-difference method. Since gradients of pressure are much smaller than gradients of both the temperature and density, the ...
J. Słomczyńska
doaj
Boundary element formulations for the numerical solution of two-dimensional diffusion problems with variable coefficients [PDF]
, 2012 This is the post-print version of the final paper published in Computers & Mathematics with Applications. The published article is available from the link below.
Škerget, L +7 more
core +1 more source
Recent Advances of Slip Sensors for Smart Robotics
Advanced Materials Technologies, EarlyView.This review summarizes recent progress in robotic slip sensors across mechanical, electrical, thermal, optical, magnetic, and acoustic mechanisms, offering a comprehensive reference for the selection of slip sensors in robotic applications. In addition, current challenges and emerging trends are identified to advance the development of robust, adaptive,
Xingyu Zhang +8 more
wiley +1 more source