Results 41 to 50 of about 7,880,006 (253)
Influence of the shot-peening intensity on the structure and near-surface mechanical properties of Ti40Zr10Cu38Pd12 bulk metallic glass [PDF]
This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics.Shot-peening (SP) changes the near-surface structure and mechanical properties of a Ti40Zr10 Cu 38Pd12 bulk ...
Baró, M. D. +7 more
core +3 more sources
Effects of surface nanocrystallization on the anodic oxidation behavior of Aluminum
Gradient microstructures on the surface of metals induced by severe shot peening (SSP) is relatively a new research topic in the field of severe plastic deformation processing.
Asghar Heydari Astaraee +3 more
doaj +1 more source
The high cycle fatigue behavior of TC11 titanium alloy with lamellar structure before and after surface nanocrystallization was studied by supersonic fine particle bombardment (SFPB).The microstructure of the high cycle fatigue fracture and its vicinity ...
WU Yong-li +7 more
doaj +1 more source
Low temperature magnetic behaviour of glass-covered magnetic microwires with gradient nanocrystalline microstructure [PDF]
Slow nanocrystallization driving dynamics can be affected by the combination of two factors: sample residual stresses and sample geometry. This effect is evidenced at the initial stages of nanocrystallization of amorphous CoFeSiBCuNb magnetic microwires.
A. Hernando +4 more
core +2 more sources
Enhanced initial biodegradation resistance of the biomedical Mg-Cu alloy by surface nanomodification
Mg-Cu alloys are promising antibacterial implant materials. However, their clinical applications have been impeded by their high initial biodegradation rate, which can be alleviated using nanotechnology by for example surface nanomodification to obtain a
Wen Zhang +7 more
doaj +1 more source
Effect of surface nanocrystallization on corrosion behaviour of coated steel in chloride solution
A nanocrystalline (NC) layer was fabricated on the surface of the low-alloy steel 15CrMo using high-energy shot peening. Two kinds of conversion coatings including the chemical conversion coating and electrochemical conversion coating were separately ...
Liuyan Zhang +5 more
doaj +1 more source
Nanocrystallization and Amorphization Induced by Reactive Nitrogen Sputtering in Iron and Permalloy
Thin films of iron and permalloy Ni80Fe20 were prepared using an Ar+N2 mixture with magnetron sputtering technique at ambient temperature. The nitrogen partial pressure, during sputtering process was varied in the range of 0 to 100%, keeping the total ...
A. Guinier +12 more
core +1 more source
The thermal stability and characteristics of the surface of the Fe 82 Nb 2 B 14 RE 2 (RE = Y, Gd, Tb, Dy) amorphous alloys were studied by differential scanning calorimetry and atomic force microscopy methods.
L Boichyshyn, M-O Danyliak, B Kotur
doaj +1 more source
The ultrastrong gradient nanostructured dual-phase high entropy alloy (DP-HEA) Fe50Mn30Co10Cr10 has been fabricated by an efficient surface nanocrystallization method, e.g. ultrasonic shot peeing (USP) at room temperature.
Fei Yin +9 more
doaj +1 more source
The Ultimate Fate of Supercooled Liquids
In recent years it has become widely accepted that a dynamical length scale {\xi}_{\alpha} plays an important role in supercooled liquids near the glass transition.
Anderson S. R. +42 more
core +1 more source

